DJI EB3WBC Fly App User Guide
- June 16, 2024
- DJi
Table of Contents
EB3WBC Quick Start Guide
Aircraft
1. Horizontal Omnidirectional Vision System
2. Gimbal and Camera
A Tele Camera
B Wide Camera
3. Downward Vision System
4. Auxiliary Bottom Light
5. Infrared Sensing System
6. Battery Buckles
7. Landing Gears (Built-in antennas)| 8. Front LEDs
9. Aircraft Status Indicators
10. Motors
11. Propellers
12. Intelligent Flight Battery
13. Power Button
14. Battery Level LEDs
15. USB-C Port
16. microSD Card Slot
17. Dongle Compartment Cover
---|---
Remote Controller RC331
1. Antennas
2. Control Sticks
3. Status LED
4. Battery Level LEDs
5. Power Button
6. Flight Mode Switch
7. Flight Pause/Return to Home (RTH) Button
8. Touchscreen
9. Customizable Buttons
10. Control Sticks Storage Slot| 11. Air Intake
12. Air Vent
13. USB-C port
14. microSD Card Slot
15. Focus/Shutter Button
16. Camera Control Dial
17. Record Button
18. Gimbal Dial
---|---
Charge to Activate
Check
Battery Level, Power On/Off 
Press once to check the battery level.
Press, then press and hold to power on/off.
Prepare the Aircraft
Prepare the Remote Controller
Ready to Fly
Power on the remote controller and the aircraft, then launch the DJI Fly App.
Fly
Auto take-off/landing:
Auto Takeoff
Auto Landing
. Manual Takeoff / Landing
Combination stick command to start/stop the motors Left stick up (slowly) to
take off Left stick down (slowly) until you touch the ground Hold a few
seconds to stop the motors
Remote controller operation
Specifications
Aircraft (Model: EB3WBC)
Operating Temperature| -10 to 40°C (14° to 104°F)
Operating Frequency| 2.4000-2.4835 GHz; 5.725-5.850 GHz; 5.150-5.25GHz
Transmitter Power (EIRP)| 2.4 GHz: <26 dBm (FCC), <20 dBm (CE/SRRC/MIC)
5.1GHz: <23 dBm (FCC/CE)
5.8 GHz: <26 dBm (FCC/SRRC), <14 dBm (CE)
Wi-Fi
Protocol| 802.11a/b/g/n
Operating Frequency| 2.400-2.4835 GHz; 5.150-5.250 GHz; 5.725-5.850 GHz
Transmitter Power (EIRP)| 2.4 GHz: <23 dBm (FCC), <20 dBm (CE/SRRC/MIC)
5.2 GHz: <23 dBm (FCC/CE/SRRC/MIC)
5.8 GHz: <23 dBm (FCC/SRRC), <14 dBm (CE)
Remote Controller (Model: RC331)
Operating Temperature| -10 to 40°C (14° to 104°F)
Operating Frequency| 2.400-2.4835 GHz; 5.725-5.850 GHz; 5.150-5.25GHz
Transmitter Power (EIRP)| 2.4 GHz: <26 dBm (FCC), <20 dBm (CE/SRRC/MIC)
5.1GHz: <23 dBm (FCC/CE)
5.8 GHz: <26 dBm (FCC), <23 dBm (SRRC), <14 dBm (CE)
Wi-Fi
Protocol| 802.11a/b/g/n/ax
Operating Frequency| 2.400-2.4835 GHz; 5.150-5.250 GHz; 5.725-5.850 GHz
Transmitter Power (EIRP)| 2.4 GHz: <23 dBm (FCC), <20 dBm (CE/SRRC/MIC)
5.2 GHz: <23 dBm (FCC/CE/SRRC/MIC)
5.8 GHz: <23 dBm (FCC/SRRC), <14 dBm (CE)
Intelligent Flight Battery (Model: BWX233-4241-14.76)
Charging Temperature| 5 to 40℃ (41 to 104°F)
Capacity| 4241 mAh
Max Charging Power| 129 W
Standard Voltage| 14.76 V
FCC Compliance Notice
Supplier’s Declaration of Conformity
Product name: DJI Air 3
Model Number: EB3WBC
Responsible Party: DJI Research LLC
Responsible Party Address: 435 Portage Ave, Palo Alto, CA 94306
Website: www.dji.com
We, DJI Research LLC, being the responsible party, declares that the above
mentioned model was tested to demonstrate complying with all applicable FCC
rules and regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
The aircraft complies with FCC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the
FCC radio frequency exposure limits, human proximity to the antenna shall not
be less than 20cm during normal operation. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
This remote controller complies with FCC radiation exposure limits set forth
for an uncontrolled environment. End user must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter.
The portable device is designed to meet the requirements for exposure to radio
waves established by the Federal Communications Commission (USA).These
requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The
highest SAR value reported under this standard during product certification
for use when properly worn on the body. The portable device is designed to
meet the requirements for exposure to radio waves established by the Federal
Communications Commission (USA).
These requirements set a SAR limit of 4 W/kg averaged over ten gram of tissue.
The highest SAR value reported under this standard during product
certification for use when properly worn on the limbs.
ISED Compliance Notice
CAN ICES-003 (B) / NMB-003(B)
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference. (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
This aircraft complies with RSS‐102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
This remote controller complies with RSS-102 radiation exposure limits set
forth for an uncontrolled environment. End user must follow the specific
operating instructions for satisfying RF exposure compliance. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter. The portable device is designed to meet the requirements for
exposure to radio waves established by the CNR-102.
These requirements set a SAR limit of 1.6 W/kg averaged over one gram of
tissue. The highest SAR value reported under this standard during product
certification for use when properly worn on the body.
These requirements set a SAR limit of 4W/kg averaged over ten grams of tissue.
The highest SAR value reported under this standard during product
certification for use when properly worn on the limbs.
The device for operation in the band 5150–5250 MHz is only for indoor use to
reduce the potential for harmful interference to co-channel mobile satellite
systems.
View E-label
Swipe down from the top of the home screen to enter Quick Settings, tap and
select Compliance Info.
5150-5250MHz /Indoor use Only
In case of STA,
EU & UK Compliance Notice
EU Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby declares that this
device (DJI Air 3) is in compliance with the essential requirements and other
relevant provisions of the Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is available online at www.dji.com
/euro-compliance
EU contact address: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany
GB Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby declares that this
device (DJI Air 3) is in compliance with the essential requirements and other
relevant provisions of Radio Equipment Regulations 2017.
A copy of the GB Declaration of Conformity is available online at www.dji.com
/euro-compliance
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
Environmentally friendly disposal
**** Old electrical appliances must not be disposed of together with the
residual waste, but have to be disposed of separately. The disposal at the
communal collecting point via private persons is for free. The owner of old
appliances is responsible to bring the appliances to these collecting points
or to similar collection points. With this little personal effort, you
contribute to recycle valuable raw materials and the treatment of toxic
substances.
This device is restricted to indoor use when operating in the 5150-5250MHz
frequency range in all EU/EFTA member states and Turkey.
BE| BG| CZ| DK| DE| EE| IE| EL| ES| FR
HR| IT| CY| LV| LT| LU| HU| MT| NL| AT
PL| PT| RO| SI| SK| Fl| SE| UK (NI)| TR| NO
CH| IS| LI| | | | | | |
UK
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>