Sagemcom Optimum Stream Remote User Manual

Get to know your
Optimum Stream remote

Safe Usage and Certifications:

1. Place the product on a flat surface.
2. Connect the manufacturer-supplied AC power adapter. The Optimum Stream requires the use of a 12 VDC, 1A power adapter in compliance with PS2 or LPS according to annex Q of UL 62368-1. Only use a manufacturer-supplied and approved power adapter. Always first plug the adapter lead into the Optimum Stream, then the AC adapter into the AC wall socket. If you do not follow this sequence for set-up, you may get an electric shock.
3. Connect the power adapter to the AC outlet in accordance with the markings on the identification label (voltage, current, and frequency of the electricity network).
4. Optionally, connect the Ethernet cable to the RJ45/Ethernet ports. Then connect the other end of the Ethernet Cable to the Ethernet port of your internet service device..

When using this device, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons including the following:

1. Do not use this product near water and avoid contact with moisture. For example, do not use it near a bathtub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool. Care should be taken so that liquids are not spilled on this equipment.
2. This equipment is for indoor use only, do not place or install it in an outdoor location.
3. Do not overload wall outlets or extension cords. Doing so can result in the risk of fire or electrical shock.
4. The equipment should be situated away from heat sources such as radiators, heat registers, stoves, or other heat-producing appliances and equipment.
5. Care should be taken to ensure that the power cord is routed so it is not likely to be walked on or pinched by items placed upon or next to it.
6. Unplug this equipment before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning only.
7. This equipment is not user serviceable and is to be serviced by qualified personnel only. Do not disassemble this equipment. If service is required, disconnect all power from the equipment and consult qualified service personnel.
8. To disconnect this equipment from AC power, unplug the power supply from the AC wall socket.
9. Make sure the power socket to which you connect the power cord is easily accessible and as close as possible to the equipment so that the appliance can be unplugged quickly in case of a problem.

Radio Frequency Interference Statement

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

FCC Radio Frequency Radiation Exposure Statement
This equipment complies with “FCC1.1310 for radiofrequency radiation exposure limits set forth for an uncontrolled environment”.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device produces radio frequency energy in the 2.4 GHz and 5 GHz spectrum. The antenna should be positioned to keep a minimum distance of 30cm (0.98ft) from the radiating element to any nearby person.

Federal Communications Commission (FCC) Statements
FCC ID: VW3DIW377
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Modifications:

You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
FCC Responsible Party: Sagemcom USA
14651 N. Dallas Parkway
Suite 900
Dallas, TX 75254
Phone: 972-674-4100

Model Name: DIW377 ALT US
Product Name: Optimum Stream

Licenses and Trademarks
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Manufactured under license from Dolby Laboratories. Dolby, Dolby Audio, Dolby Vision and the double-D symbols are trademarks of Dolby Laboratories Licensing Corporation. Wi-Fi® and Wi-Fi logo are registered trademarks of Wi-Fi Alliance. Bluetooth® is a registered trademark of Bluetooth SIG, Inc. Google is a trademark of Google LLC.

This product contains technology subject to certain intellectual property rights of Microsoft. Use or distribution of this technology outside of this product is prohibited without the appropriate license(s) from Microsoft. Content owners use Microsoft PlayReady™ content access technology to protect their intellectual property, including copyrighted content. This device uses PlayReady technology to access PlayReady-protected content and/or WMDRM- protected content. If the device fails to properly enforce restrictions on content usage, content owners may require Microsoft to revoke the device’s ability to consume PlayReady-protected content. Revocation should not affect unprotected content or content protected by other content access technologies. Content owners may require you to upgrade PlayReady to access their content. If you decline an upgrade, you will not be able to access content that requires the upgrade.

This product is licensed under the AVC patent portfolio license for the personal and noncommercial use of a consumer to (i) encode video in compliance with the AVC standard (“AVCvideo”) and/or (ii) decode AVC video that was encoded by a consumer engaged in the personal and non-commercial activity and/or was obtained from a video provider licensed to provide AVC-video. No license is granted or shall be implied for any other use. Additional information may be obtained from MPEG LA, LLC see http://www.mpegla.com. Covered by one or more claims of the patents listed at patentlist.hevcadvance.com. All other brands and logos are trademarks or registered trademarks of their respective owners.

Issued by Sagemcom Broadband SAS
Sagemcom Broadband
250, route de l’Empereur – 92500 RUEIL MALMAISON – France
© Sagemcom Broadband SAS 2022
All rights reserved. Subject to availability.
Rights of modifications reserved.
www.sagemcom.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>