CRYSTORAMA 8105-PN Paxton Four Light Chandelier Instruction Manual
- June 12, 2024
- CRYSTORAMA
Table of Contents
CRYSTORAMA 8105-PN Paxton Four Light Chandelier
Product Information
This product is a model #8105-PN 5×5 chandelier from Crystorama. It can be used for hanging from a ceiling or for semi-flush mounting. The product comes with all the necessary components, including mounting hardware, canopy, ball nut, fabric shade, socket, crystal bobeche, small crystal ball, and big crystal ball. The product requires 4 candelabra bulbs, with a maximum wattage of 60 watts per bulb. The electrical components should be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes. The product is also accompanied by a warning that it contains lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm.
Product Usage Instructions
Hanging Installation
- Insert the shade spoke in between top and bottom knurled nut.
- Secure the shade by twisting the top knurled nut.
- Slide the crystal bobeche over the socket.
- Install the recommended bulbs into each socket.
- Screw the crystal ball into the bottom frame.
Semi-Flush Installation
- Hook the canopy onto the loop on top of the fixture.
- Raise the fixture up to the ceiling and connect the wires.
- Secure the canopy onto the outlet box by ball nuts.
Note: Before installation, make sure to read and follow all safety precautions and warnings provided in the user manual. If you are unsure about any aspect of the installation process, consult a licensed electrician for assistance.
DIMENSIONS
For Hanging
For Ceiling
All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes.
You will need 4-Candelabra Bulb
60 watts Max Bulb not included
USE LED BULBS FOR EXTENDED USE
This fixture is DRY rated
How to Install
- Insert the shade spoke in between top and bottom knurled nut.
- Secure the shade by twisting the top knurled nut.
- Slide the crystal bobeche over the socket.
- Install the recommended bulbs into each socket.
- Screw the crystal ball into the bottom frame.
For Semi-flush
- Hook the canopy onto the loop on top of the fixture.
- Raise the fixture up to the ceiling and connect the wires.
- Secure the canopy onto the outlet box by ball nuts.
WARNING : This product can expose you to Lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm. For more information go to www.P65Warnings.ca.gov
Part Numbers
- A. Mounting Hardware
- (1) Mounting Plate
- (2) Mounting Screws
- (3) Wire Nut
- B.(1)Canopy;5″x5″x0.7″h;XMO8105PNCAN5IN
- C.(2)Ball nut
- D.(1)Chain;72”L x Ø4.0mmT;XMO8105PNCHA4MM
- E.(1)Fixture Loop
- F.(2)Knurled Nut
- G.(1)Fabric Shade;16”x16”x7”h;XMO8105SHA16IN
- H.(4)Socket
- I.(4)Crystal Bobeche
- J.(4)Small Crystal ball
- K.(1)Big crystal ball
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>