GE 22002 Highlands Pine Pre-Lit Christmas Tree Instruction Manual
- June 12, 2024
- GE
Table of Contents
GE 22002 Highlands Pine Pre-Lit Christmas Tree
Nicolas Holiday Ltd. thanks you for purchasing this pre-lit Christmas tree. Should you have any problems with your tree, visit us at www.geholidaylighting.com for more information. You can call our toll free number at 1-877-398-7337. Check our website for latest service hours and assembly instruction videos.
Assembly Instructions
-
Carefully unpack the carton. Remove bubble wrap and inspect the sections of your tree. The carton should include sections “A”, “B” and “Top”, as well as a Tree Stand.
-
The tree stand should be open and set at 90° angle.
-
Insert Section A into tree stand, tighten the thumbscrew. Then insert the plug into an electrical wall outlet.
-
Untie RED twist-tie to release branch panels. All branches should fall into place with a gentle pull on the outer layer of branches.
Start at the inner and stagger the tips. Move each tip up to 40°. Make tips 2 & 3 to horizontial, tip 4 to vertical and tips 5 and 6 up to 45°.
-
To assemble the section “B”, properly insert section “B” into the top of section “A”.
Adjust branch tips, as needed, for a fuller look.
To electrically connect the sections,
fully insert the plug from the extension cord attached to the pole of the
middle section into the extension cord outlet attached to the pole near the
top of the bottom section. -
Repeat “Step 4” for shaping.
-
To assemble the tree top, properly insert the “TOP” section into the top of section “B”. (See Fig. D) Adjust branch tips, as needed, for a fuller look.
To illuminate the top, fully insert the
plug from the top section into either the end connector or the extension cord
outlet on or near the top layer of branches of previously assembled pole.
Troubleshooting Tips
If the tree does not illuminate, make certain the wall switch is turned on. If
one section of your tree does not illuminate, check that section for loose or
missing bulbs, all factory connections are properly made or that you properly
made all the electrical connections between each tree section.
DISCLAIMER: DO NOT USE OR INSTALL ANY ADDITIONAL CHRISTMAS LIGHTING OR
ORNAMENTATION THAT IS POWERED BY A LIGHT BULB SOCKET. DOING THIS MAY RESULT IN
DAMAGE TO YOUR CHRISTMAS TREE OR CAUSE PERSONAL INJURY. DOING THIS, WILL
RESULT IN A VOID OF THE LIMITED WARRANTY OF THIS PRODUCT.
Disconnect the decorative item from the power source before performing any
maintenance or cleaning.
-
Remove the tree’s main extension cord plug from the wall outlet.
-
Starting at the top, disconnect the “TOP” from section “B” and then disconnect section “B” from section “A”.
Note: Gently fold the tips in
branches and fold the branches up toward the center. Care should be taken to
avoid damage to the lights. -
Remove section “A” from the tree stand and close tree stand to place into the carton.
-
Refer to the drawing on how to repack your tree.
IMPORTANT: Store your carton neatly in a cool, dry location protected from
sunlight to prolong the tree life and to better keep the light sets in working
order. Do not place a heavy load on the carton to avoid damage to or crushing
the carton and tree inside.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>