George Kovacs P5332-613-L Double Barrel 2 Light Polished Nickel LED Vanity Light Instruction Manual

George Kovacs P5332-613-L Double Barrel 2 Light Polished Nickel LED

Vanity Light

Product Information: P533X-613-L Wall Mounted Fixture

The P533X-613-L is a wall-mounted fixture suitable for indoor use. The fixture comes with a mounting plate set, glass shade, and necessary hardware for installation. The fixture is dimmable with ELV and/or LED compatible wall dimmer switch.

Product Usage Instructions

1. Before installation, shut off power at the fuse box or circuit breaker box and remove the old fixture, including the mounting hardware.
2. Unpack the new fixture carefully and lay out all the parts on a clear area. Take care not to misplace any small parts necessary for installation.
3. Secure the mounting plate (B) to the junction box (A) using mounting screws (E) (Size: #8-32*1/2L). The side of the mounting plate marked GND must face out.
4. Slide the glass shade (H) into the aluminum profile (K), place the rubber pad (I) onto the glass shade hole. Secure the glass shade using thumb screw (J).
5. Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (B) using the green screw provided.
6. Tuck wire connections neatly inside the junction box.
7. Place fixture body (G) onto mounting plate (B) and secure with screws (D).
8. Make sure that the installation is complete and return power to the junction box. Test the fixture.

CAUTION: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base or fixture body only.
IMPORTANT: The fixture should be installed by a qualified electrician to ensure proper wiring and installation.

INSTALLATION INSTRUCTIONS FOR P533X-613-L

PREPARATION

1. Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to misplace any small parts necessary for installation
   MOUNTING THE FIXTURE (Fig. 1)

3. Secure mounting plate (B) to junction box (A) (not included) using mounting screws (E) (Size: #8-32*1/2”L). The side of the mounting plate marked “GND” must face out.

4. Slide glass shade (H) into aluminum profile (K), place rubber pad (I) onto glass shade hole. Secure glass shade using thumb screw (J).
   CONNECTION THE WIRES (Fig. 2)

5. Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (B) using the green screw provided.

6. Tuck wire connections neatly inside the junction box.
   FINISHING THE INSTALLATION (Fig. 1)

7. Place fixture body (G) to mounting plate (B) and secure with screws (D). Your installation is now complete. Return power to the junction box and test the fixture.
   CAUTION / ATTENTION: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base or fixture body only.
   IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation.
   Dimmable with ELV and/or LED compatible wall dimmer switch.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>