C Cattleya CA2273-H Natural Rattan Cage Pendant Light Instruction Manual
- October 30, 2023
- C Cattleya
Table of Contents
C Cattleya CA2273-H Natural Rattan Cage Pendant Light
Product Information
The CA2273-H is a light fixture that requires electrical installation. It comes with a mounting plate, screws, and wires for connection. The fixture does not include a bulb. To avoid the risk of electrical shock, it is essential to turn off the power before installing or servicing the fixture.
Product Usage Instructions
- Begin by turning off the power supply to the area where the fixture will be installed.
- Locate a suitable location for the fixture and install the mounting plate using the provided screws.
- Identify the live wire, which is typically black, and connect it to the corresponding wire from the fixture.
- Identify the negative wire, which is typically white, and connect it to the corresponding wire from the fixture.
- Tighten all wire connections securely.
- Attach the fixture to the mounting plate using the provided screw.
- Install a suitable bulb into the fixture according to the manufacturer’s instructions.
- Turn on the power supply and test the fixture to ensure it is working correctly.
Following these steps will ensure that your CA2273-H light fixture is safely installed and ready for use. If you have any questions or concerns about installing or using this product, please consult a qualified electrician or contact our customer service department for assistance.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
NOTES
- Before installing, consult local electrical codes for wiring and grounding requirements.
- READ AND SAVE THESE INSTRUCTIONS.
- Attach the mounting plate to the outlet box by using two mounting screws.
- Pull out the wires and grounding wire from the outlet box. Make wire connections using the wire nuts, as follow:
- Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
- Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
- Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap with the green grounding screw. Then connect it to the house grounding wire with the wire nut. Carefully put the wires back into the outlet box.
- Attach the back plate to the mounting plate by inserting the screws, then secure it with two nuts.
CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the wall surface to prevent water from seeping into the out let box. Turn on the power at fuse or circuit box.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>