vtech 541300 Switch and Battlers T-Rax Drift Car Instruction Manual

vtech 541300 Switch and Battlers T-Rax Drift Car

INTRODUCTION

Switch into fun with the Switch & Go® T-Rex Drift Car. Transform this ferocious T-Rex into an agile Drift Car and back in just a few simple steps. Ready to smash and crash? Here we go!

INCLUDED IN THIS PACKAGE

• Switch & Go® T-Rex Drift Car
• Quick Start Guide

WARNING: All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety.
NOTE: Please save this Instruction Manual as it contains important information.

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Find the battery cover on the back of the unit, use a screwdriver to loosen the screw and then open the battery box.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.

Note: If there is no response when the dino is switched on, please install brand new batteries and try switching the dino on again.

WARNING: Adult assembly required for battery installation.
Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

• Insert batteries with the correct polarity (+ and -).

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.

• Only batteries of the same or equivalent type as recommended are to be used.

• Do not short-circuit the supply terminals.

• Remove batteries during long periods of non-use.

• Remove exhausted batteries from the toy.

• Dispose of batteries safely. Do not dispose of batteries in fire.
  RECHARGEABLE BATTERIES

• Remove rechargeable batteries from the toy before charging.

• Rechargeable batteries are only to be charged under adult supervision.

• Do not charge non-rechargeable batteries.

PRODUCT FEATURES

1. Off / Low / High Volume Selector
   To turn the unit On or adjust the volume, slide the switch to the Low or High Volume position.
   To turn the unit Off, slide the switch to the Off position

2. Game Button
   Press the Game Button to hear fun phrases and cool dinosaur sounds in Dino mode,or to hear fun phrases and great vehicle sounds in Vehicle mode.

3. Crash Trigger
   Hit the Crash Trigger to see crash damage with a fiery light effect and hear dino or vehicle sounds.

4. Automatic Shut-Off
   To preserve battery life, T-Rex Drift Car will automatically turn off after approximately 40 seconds without input. T-Rex Drift Car can be woken up again by pressing the Game Button, hitting the Crash Trigger or by switching between Dino mode and Vehicle mode. T-Rex Drift Car will also automatically turn off when battery power is very low.

TRANSFORMATION

1. Dino mode.
2. Rotate hands toward the dino’s head and toes back toward the dino’s tail.
3. Pull the legs up and toward the dino’s body as illustrated.
4. Flip the rear tires back as illustrated.
5. Swing the windshield forward as illustrated.
6. Vehicle mode.

Note: To switch from Vehicle mode to Dino mode, follow the above steps in reverse order.

CARE & MAINTENANCE

1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat sources.
3. Remove the batteries if the unit will not be in use for an extended period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.

IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S. 1-877-352-8697 in Canada, or visit our website vtechkids.com and fill out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Supplier’s Declaration of Conformity

47 CFR § 2.1077 Compliance Information

Trade Name:            VTech®
Model:                      5413
Product Name:         Switch & Go® T-Rex Drift Car Responsible Party: VTech Electronics North America, L.L.C. Address:  1156 W. Shure Drive, Suite 200 Arlington Heights, IL 60004
Website:                  vtechkids.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
CAN ICES-3 (B)/NMB-3(B)

Visit our website for more information about our products, downloads, resources and more.
vtechkids.com
vtechkids.ca
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty

TM & © 2021 VTech Holdings Limited.
All rights reserved.
Printed in China.
91-004010-000 US CA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>