GEORGE KOVACS P5393-613 Gramercy 3-Light Polished Nickel Shaded Pendant Light Instruction Manual
- October 30, 2023
- GEORGE KOVACS
Table of Contents
GEORGE KOVACS P5393-613 Gramercy 3-Light Polished Nickel Shaded Pendant
Light Instruction Manual
INSTALLATION INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
PREPARATION (Fig.1)
-
Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small partsnecessary for installation.
-
Secure rod (E) onto all thread (G) on cross assembly (K).
-
Determine the desired hanging height and thread rods (F1, F2 and F3) to the all thread on rod (E). Attach canopy (C) by screwing onto rod (F1). Carefully pass the wires through each rod during assembly. Note: Remove the all thread, if installing with one 6” rod only.
-
Attach mounting plate (A) to the junction box (not included) with mounting screws (B) (Size: #8-32N*L0.5”). The side of the mounting plate (A) with “GND” marked on it and two convex points must face out.
CONNECTING THE WIRES (Fig. 2)
-
Connect the electrical wires as shown in fig 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided.
-
Tuck wire connectors neatly into the junction box.
FINISHING THE INSTALLATION (Fig.1) -
Place canopy (C) over mounting plate (A) and secure with screws (D).
-
Install (3) three medium base bulbs (J) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification — DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
-
Secure decorative parts (L) on cross assembly (K) with screws (I).
-
Place cloth shade (H) onto cross assembly (K) and secure with screws (I).
Your installation is now complete. Return power to the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
Important:
Fixture should be installed by a wualified electrician to ensure proper wiring
and installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>