GEORGE KOVACS P5394-613 Gramercy 4-Light Polished Nickel Shaded Pendant Light Instruction Manual
- October 30, 2023
- GEORGE KOVACS
Table of Contents
GEORGE KOVACS P5394-613 Gramercy 4-Light Polished Nickel Shaded Pendant
Light
Product Information
The PINSTALLATION INSTRUCTIONS provide step-by-step guidance for installing Item#P5394-613. The product comes with a mounting plate (A), rod (E), cross assembly (K), canopy (C), decorative parts (L), cloth shade (H), medium base bulbs (J) and screws (B, D, and I).
PINSTALLATION INSTRUCTIONS
Preparation
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
- Unpack the new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
- Secure rod (E) onto all thread (G) on cross assembly (K).
- Determine the desired hanging height and thread rods (F1, F2, and F3) to the all thread on rod (E). Attach canopy (C) by screwing onto rod (F1). Carefully pass the wires through each rod during assembly. Note: Remove the all thread if installing with one 6 rod only.
- Attach mounting plate (A) to the junction box with mounting screws (B) (Size: #8-32N*L0.5). The side of the mounting plate (A) with GND marked on it and two convex points must face out.
Connecting the Wires
- Connect the electrical wires as shown in fig 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided.
- Tuck wire connectors neatly into the junction box.
Finishing the Installation
- Place canopy (C) over the mounting plate (A) and secure with screws (D).
- Install (4) four medium base bulbs (J) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification–DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
- Secure decorative parts (L) on cross assembly (K) with screws (I).
- Place cloth shade (H) onto cross assembly (K) and secure with screws (I).
Your installation is now complete. Return power to the junction box and test
the fixture.
Note: The illustration (Fig. 1) on this manual is for installation
purposes only. It may or may not be identical to the fixture purchased.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY IRING AND INSTALLATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>