Karlik ICUSB-6 Double USB Charger User Manual
- October 30, 2023
- KarliK
Table of Contents
Karlik ICUSB-6 Double USB Charger
Product Usage Instructions
- Before using the ICUSB-6 double USB charger, ensure that it is connected to a power source with an input voltage of 100-240V AC and a frequency of 50/60Hz.
- Ensure that the device you want to charge is compatible with the charging parameters of the ICUSB-6 charger.
- Connect the device to the charger using a USB cable.
- The charger has two USB ports. You can charge up to two devices simultaneously.
- Once the device is connected, the charging process will begin automatically.
- When the device is fully charged, disconnect it from the charger.
- When not in use, disconnect the ICUSB-6 charger from the power source to avoid idle power supply consumption.
Specification of ICUSB-6 double USB charger
The ICUSB-6 charger is intended to charge devices like smartphones, MP3 players and other electronic equipment. Before connecting the device, check compliance of the charger with charging parameters of the given device.
Dane technique
| Number of USB ports (type A) | 2 |
|---|---|
| Nominal input voltage | 100-240V AC; 50/60Hz |
| Nominal input current | 0,25 A |
| Nominal output voltage | 5 V DC |
| Nominal output current | 3.1 A (total value for the whole mechanism) |
| Ingress protection degree | IP 20 |
Warranty conditions
Warranty is granted for a period of 12 months of the date of purchase. The defective DCUSB-6 charger along with the proof of purchase should be sent to the manufacturer or to the seller. Warranty does not include mechanical damages, defects resulting from unauthorised repairs and improper use of the product. Warranty period will be extended for the duration of the repair.
ASSEMBLY INSTRUCTIONS
- Remove the glass panel (1) with the label applying a knife or a flat screwdriver in the recess (3).
- Remove the screw (2).
- Dismantle the USB charger modules (4).
- Remove the spacer frame (5) from the assembly block (7). Pull away the block tabs or pull the frame tightly to do this.
- Set the assembly block in the box (9) with tabs or screws at the box (8).
- Insert the spacer frame in the external frame (6) and snap the entire set on the tabs protruding from the assembly block.
- Connect the wires of the installation to the USB charger module as shown in Figure 2.
- Insert the USB charger modules in the intermediary unit.
- Screw down the intermediary unit to the assembly block.
- Attach the label and glass pane.
NOTE: The installation must be done by a person with sufficient qualifications, with power supply disconnected, and must comply with national safety standards. The connection to the installation should be done as shown in Figure 2. With improper connection, the charger may be damaged or may work incorrectly. USB charger mechanism with idle power supply consumes less than about 0,2W.
Karlik Elektrotechnik Sp. z o. o.
ul. Wrzesinska 29
62-330 Nekla
Tel: +48 61 437 34 00
E-mail: karlik@karlik.pll
Web: www.karlik.pl
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>