OLIGHT Javelot LED Torch User Manual

Javelot LED Torch
User Manual

Powerful, Portable, Long-range EDC Flashlight

IN THE BOX

Table 1: Flashlight

• Above data are tested per ANSI/NEMA FL 1-2009 standard in Olight’s labs for reference.
  Table 2: USB Magnetic Charging Cable

Figure 1
Remove the insulating film

SIDE SWITCH OPERATION:

|
---|---
|
|
|
|
|

HOW TO OPERATE

1. Product specification, see Table 1 and Table 2;

2. Operating instructions as below:
   2.1 Remove the insulating film before first use, see Figure 1;
   2.2 Charging, see Figure 2;

3. Side switch operating instructions as below:
   3.1 ON/OFF, see Figure 3;
   Quickly press to turn it on/off.
   3.2 Lockout/Unlock, see Figure 4;
   When the flashlight is on, press and hold the switch (for about 2 seconds) to access lockout mode (the flashlight will enter Moonlight briefly and then switch off to signal lockout mode activation). In lockout mode, if you operate the  switch for a non-unlock purpose, the indicator at the center of the switch will briefly light up red to signal that the light is still in lockout mode. To unlock it, please press and hold the switch for about one second until the Moonlight is on.
   3.3 Moonlight, see Figure 5;
   When the flashlight is off, press and hold the switch for over one second to access the Moonlight mode. If the light was turned off in Moonlight mode, simply press the switch.
   3.4 Turbo, see Figure 6;
   Quickly double press the side switch to enter into Turbo, double press again to return to the memorized mode. If the battery level is low, the light will return to High mode.
   3.5 Strobe, see Figure 7;
   Press the switch for 3 times or more to activate Strobe mode. To quit this mode, single press or press and hold the switch.
   3.6 Change brightness level, see Figure 8;
   When the flashlight is on, press and hold the side switch and it will, starting from the present brightness level, automatically cycle through Moonlight / Turbo – Low – Medium – High – Low. The mode is selected when the side switch  has been released. (Please note: Moonlight and Turbo are not in the automatic cycle ).

4. Tail switch operating instructions below：
   4.1 Press slightly for Low mode, see Figure 9;
   Quickly press slightly to turn the light on and access Low.
   4.2 Press slightly and hold for momentary on, see Figure 10;
   Press and hold for momentary on (Low).
   4.3 Press hard for High mode, see Figure 11;
   Quickly press hard to turn the light on and access High.
   4.4 Press hard and hold for momentary on, see Figure 12;
   Press and hold for momentary on (High).
   4.5 Change from Low to High, see Figure 13;
   When in Low mode, quickly press hard to access High mode, press again to turn it off.

5. Battery level indicator, see Figure 14;

CAUTION

• Do not look directly at the light source or shine to eyes, or else it may cause temporary blindness or permanent damage to the eyes.
• Do not cover the light outlet at close range, as the energy radiated by the light may damage the product’s light emitting components, and even cause external objects to burn.
• Non-standard batteries, do not take them out for charging.
• Please use the standard charging cable for charging.
• Do not touch the hot surface, or else it may cause skin burns.
• Don’t leave the light in a car where the inside of temperature may be over 60℃, or in similar places.
• Do not use damaged or deformed batteries, or those with a broken casing.

NOTICE

• DO NOT leave the light in any type of fabric bag or fusible plastic container under high temperature.
• Active thermal management: The built-in proximity sensor monitors temperature in real-time and suppresses overheating by reducing output.
• Please do not short-circuit the charging port with metal or a conductor, as it will cause battery drain.
• Do not disassemble the product.
• Do not immerse the flashlight in seawater or other corrosive media as it will damage the product.
• The tail switch is magnetic, and the metal powder adsorbed on the surface will affect the function, please clean it immediately.

REMARK

• Before long term storage, please fully charge the product.
• Keep the charging port clean and dry.

WARRANTY
Within 30 days of purchase: Contact the original seller for repair or replacement.
Within 5 years of purchase: Contact Olight for repair or replacement.
Battery warranty: Olight offers a one-year warranty for all rechargeable batteries.
USB Magnetic Charging Cable: One year.
If you experience quality problems or damage with low-value fittings like lanyards or clips within 30 days of purchase under normal use conditions, please contact our after-sale service. For issues that occur after 30 days or for damage  caused by abnormal use conditions, we provide a conditional quality assurance as appropriate.
USA Customer Support : cs@olightstore.com
Global Customer Support: contact@olightworld.com
Visit www.olightworld.com to see our complete product line of portable illumination tools.

Dongguan Olight E-Commerce Technology Co., Ltd.
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road,
Changan Town, Dongguan City, Guangdong, China.
Made in China 3.4000.0648
A. 07, 20, 2022

Documents / Resources

| OLIGHT Javelot LED Torch [pdf] User Manual
Javelot LED Torch, Javelot, LED Torch, Torch
---|---

References

• Olight | Illuminate Your World.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>