TerraTrike Chain Gobbler 2 Instruction Manual
- October 30, 2023
- TerraTrike
Table of Contents
TerraTrike Chain Gobbler 2 Instruction Manual
Parts Included:
- Boom Plate (1)
- Frame Plate (1)
- Quick Release Skewer (2)
- Sleeve Washer (2)
- 10 Tooth Idler Wheel (2)
- 10mm Idler Spacer (1)
- 20mm Idler Spacer (1)
- M8x30mm Bolt (1)
- M8x40mm Bolt (1)
- M8 Nyloc Nut (2)
- 8spd Chain & Quick Link Set (1)
- 9spd Chain & Quick Link Set (1)
- 10spd Chain & Quick Link Set (1)
- 11spd Chain & Quick Link Set (1)
- Cable Management Strap (1)
Tools Needed:
- 3mm Hex Wrench
- 5mm Hex Wrench
- 13mm Socket Wrench
- Chain Tool
-
Assemble lower idler mount using boom plate, M8x30 bolt, 10mm idler spacer, idler wheel and M8 nyloc nut as shown.
-
Assemble upper idler mount using frame plate, M8x40 bolt, 20mm idler spacer, idler wheel and M8 nyloc nut as shown.
-
Locate the quick link and break chain at quick link. Connect the provided 8, 9, 10 or 11 speed chain section and let hang.
-
Remove boom clamp bolts.
-
Clip zip ties and with 3mm hex wrench remove the cable management guides.
-
Install boom plate, reinsert cable management guides, ziptie cables down and trim excess zip ties.
-
Insert quick release sleeve washers. Remove quick release caps and insert quick releases.
-
Place frame plate on end of quick releases and secure with caps.
-
Route chain through the idlers as shown.
-
Tighten and close quick release levers one at a time. Re-tighten the first lever and close again. Use cable management strap to secure loose cables to frame
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>