Spireon EDGE-M4 Vehicle Recovery and Fleet Management Owner’s Manual

EDGE-M4 Vehicle Recovery and Fleet Management
Owner’s Manual

EDGE-M4 Vehicle Recovery and Fleet Management

The MM11 tracker is a real-time vehicle tracking system designed for vehicle recovery, fleet management, and more…
IT’SRELIABLE
The ultra-thin yet durable MM11 is a high-performance cellular tracking device designed for vehicle financing, vehicle tracking, lot management, theft recovery, or other fleet applications. With an integrated GNSS receiver, the MM11 includes an LTE Cat-M modem for wireless data communication. The built in high performance antennas for both cellular radio andGNSS receivers make installation easy.
IT’S SIMPLE
No programming skills required; the MM11 comes with easy-to- configure application software and an extended AT command set. Reports can be triggered periodically or in response to events such as motion, speeding, harsh acceleration and braking, geo-fence violations, and battery status. Notifications can be sent for vehicle towing, battery removal, and more.
IT’S FUNCTIONAL
The MM11 interface supports serial communication with external terminals and devices, as well as 10 options dedicated to ignition, starter inhibit, and buzzer.
A built in 3-axis accelerometer enables motion detection and monitoring of driver behavior. An internal Lithium-Ion back up battery allows for continuous operation for up to 4 hours when the device is disconnected from the main power. An optional buzzer alert system for driver warnings is available inside the unit.

HHIGHLIGHHTS

• LTE Cat-M1 Integrated cellular and GNSS antenna
• LED status indicators for GNSS and network registration Integrated accelerometer for monitoring vehicle status &driver behavior I/O options for starter inhibit, ignition, and buzzer
• BLE5.0 support, low power consumption
• Rechargeable backup battery
• SMS, UDP,TCP, FTP & MQTT
• Up to 16 Geo-fences (polygon and circles)
• Over the air configuration and firmware update
• Extended AT Command set for flexible and easy configuration
• Small size and easy installation Internal Buzzer

The applic cation firm ware is flex xible and ca an be custom mized to be compatible e with your existing se rver at special request.
Spireon Inc c| 9724 Kings ton Pike, Suit e 800, USA

SKUs for Features

• MM11 Standard version Sequans Module GM02S+ GNSS
• AT76M IP67 enclosure

CELLULAR

•  LTE Cat-M1
• LTE-FDD Bands : 1/2/3/4/5/8/12/13/17/18/19/20/25/26/28
• Integrated high performanceantenna

GNSS

• GPS, GLONASS, Beidou& Galileo
• Tracking Sensitivity: -161 dBm
• Acquisition Sensitivity: -146 dBm
• Location Accuracy: <2.5CEP

BATTERYINFORMATION

• Type: Li-ION
• Capacity : 80mAh @ 3.7V
• Battery Life: Up to 4hours @ hibernation mode, 1 report per hour.(depends on the LTE signal strength and how many reports per hour)

ENVIRONMENTAL

• IP40 with standard enclosure version
• IP67 Ratingwith AT70M-2 enclosure
• Operation Temperature: -30°C to +75°C without Battery
• Operation Temperature: -20°C to +60°C With Battery
• Storage Temperature: -40°C to +85°C

ELECTRICAL

• Operating Voltage: 8V – 36V
• Over voltage protected
• Over current protected with resettable fuse
• Power Consumption:
  GPS Acquisition : ~ 48mA @ 12V
  GPS Tracking/Reporting : ~ 74mA @ 12V
  Sleep mode : < 1mA @12V

BLUETOOTH

•  BLE 5.0, low power consumption

PHYSICAL

• Dimensions: 93.0 x 51.0 x 15.3mm
• Internal Cellular and GPS Antennas
• Weight: ~80g

INTERFACE CONNECTORS

• IOs connector:
  2.5mm pitch 8-Pin connector
  PWR, GND (2)
  UART (RX/TX) (2)
  I/Os : Ignition, starter inhibit (Sink current 500mA Relay driver) and GPIOs (*4)

APPROVALS

• FCC
• PTCRB & Carrier Approved

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help. Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with FCC RF Exposure compliance requirements, this grant is applicable to only Mobile  Configurations. The antennas used for the transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co‐located or operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>