TerraTrike 2020 and Later Rambler Instruction Manual
- October 30, 2023
- TerraTrike
Table of Contents
TerraTrike 2020 and Later Rambler
Alignment
Inflate tires before performing alignment. The Rambler alignment measurement
is approximately 30 ½” (center tread to center tread), though slight variance
is possible.
Most importantly, make sure the alignment remains neutral with a rider seated
in the trike.
Hybrid Steering Stack Assembly*
Assemble the steering stack as shown. Grease the steerer tube before inserting into head tube. Remove any excess grease from steerer tube before installing handlebar. Grease axle before installing wheel. Torque axle to 23-25 Nm.
*Right Hand assembly depicted. Some components can be purchased individually as well as in pairs, see parts list below.
Parts List
1 | M6x30 Bolt | TT000576 |
---|---|---|
2 | Hybrid Top Cap | TT000506 |
3 | Trigger Handlebar – RH | TT000649 |
Trigger Handlebar – LH | TT000650 | |
Trigger Handlebar – Pair | TT000514 | |
M5x20 Bolt – 2qty (not pictured) | TT000301 | |
4 | Hybrid Headset Spacer | TT000520 |
5 | Hyrbid Headset Cap | TT000505 |
6 | Bushing (pre-installed) | TT000809 |
7 | Hybrid Headset Cup (pre-installed) | TT000602 |
8 | Hybrid Headset Bearing | TT000600 |
9 | Rapid Axle Hub mount – RH | TT000713 |
Rapid Axle Hub mount – LH | TT000714 | |
Rapid Axle Hub mount – Pair | TT000516 | |
10 | Rapid Axle – RH | TT000717 |
Rapid Axle – LH | TT000718 | |
Rapid Axle – Pair | TT000563 | |
11 | Axle Spacer | TT000568 |
Hybrid Steering Stack Assembly Continued*
Install Axle Spacer (11) between brake rotor and hub.
Chain Tube Setup
Mount the chain tube assemblies as shown below. Ensure the chain tubes do not rotate in the clamps after tightening the pinch bolts.
Top
Bottom
Parts List
Upper Assy. | Chain Tube, 102cm LDPE | TT000540 |
---|---|---|
Chain Tube Clamp, Rov/Ram/Mav | TT000152 | |
Spacer, Chain Tube Clamp, 15mm | TT000125 | |
M5x30 Pan Head (phillips) SS | TT000438 | |
M5x18 Pan Head (phillips) SS | N/A | |
Lower Assy. | Chain Tube, 56cm LDPE | TT000548 |
Chain Tube Clamp, Rov/Ram/Mav | TT000152 | |
Chain Tube Bracket Arm, M5, M5 | TT000640 | |
M5 Nyloc Nut SS | TT000252 | |
M5x12mm SHCS SS | TT000303 | |
M5x16mm SHCS SS | TT000443 | |
M5x18 Pan Head (phillips) SS | N/A |
Chain Routing
Cable Routing RH
Cable Routing LH
800.945.9910 | www.TerraTrike.com
4460 40th St. SE | Grand Rapids, MI 49512 USA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>