C Cattleya CA2290-2W Hardwired Dusk to Dawn Outdoor Barn Light Sconce Instructions
- October 30, 2023
- C Cattleya
Table of Contents
C Cattleya CA2290-2W Hardwired Dusk to Dawn Outdoor Barn Light Sconce
Product Information
The CA2290-2W is a light fixture that requires assembly and installation. The fixture should not be installed in areas with strong airflow or air conditioning jets. The product comes with a machine screw, ground wire, caulk, black wire, GND, outlet box, negative wire, live wire, white wire, rubber washers, decorative nuts, socket, lamp shade, and stationary ring, and requires a bulb (not included). The fixture should be installed according to local electrical codes for wiring and grounding requirements. The user manual should be read and saved for future reference.
Product Usage Instructions
- Before installation, ensure that the power is shut off to avoid electrical shock.
- Attach the mounting plate to the outlet box using two mounting screws.
- Pull out the wires and grounding wire from the outlet box.
- Connect the wires using wire nuts. The black wire should be connected to the live wire, the white wire should be connected to the negative wire, and the ground wire should be connected to the GND.
- Caulk around the back plate and wall surface using a silicone caulking compound to prevent water from seeping into the outlet box.
- Attach the socket, lamp shade, stationary ring, and decorative nuts as instructed in the user manual.
- Insert a bulb (not included) into the socket.
- Turn on the power at the fuse or circuit box.
Following these instructions will ensure that the CA2290-2W light fixture is installed safely and works properly. If you have any questions or concerns about installation or usage, please consult the user manual or contact customer support.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
CA2290-2W
WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE
NOTES
- Before installing, consult local electrical codes for wiring and grounding requirements.
- READ AND SAVE THESE INSTRUCTIONS.
- To work properly you should install this fixture and NOT confront any jets of air conditions or strong airflow
- Attach the mounting plate to the outlet box by using two mounting screws.
- Pull out the wires and grounding wire from the outlet box. Make wire connections using the wire nuts, as follow
- Connect the hot wire(usually black insulation)from the fixture to the black wire from the power source.
- Connect the neutral wire(usually white insulation)from the fixture to the white wire from the power source.
- Attach the fixture grounding wire(usually green insulation or bare wire)to the mounting strap with the green grounding screw. Then connect it to the house grounding wire with the wire nut. Carefully put the wires back into the outlet box.
- Attach the back plate to the mounting plate by inserting the screws, then secure it with two nuts.
- Align the shade onto the socket cup, and secure it with the socket Ring
- Install light bulbs (60W A19). (Bulbs not included, Please do not exceed the maximum capacity recommended on the socket.
CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the wall surface to prevent water from seeping into the outlet box. Turn on the power at the fuse or circuit box.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>