GEORGE KOVACS P1369-619 Nexpo 9 Light Coal Cluster Chandelier with Clear Glass Shades Instruction Manual
- October 30, 2023
- GEORGE KOVACS
Table of Contents
INSTALLATION INSTRUCTIONS
Item#P1369-619/66A (Rev. 01/26/2022)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
HANGING THE FIXTURE (Fig. 1)
-
Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration.
-
Shut off power at the circuit breaker and remove the old fixture including the mounting hardware.
SUGGESTED INSTALLATION (Fig. 2) -
Attach the mounting plate (A) to the junction box using mounting screws (B) (Size: #8-32N*L0.5”) as shown in Fig. 2.
-
Determine the desired hanging height and thread rods (F1, F2, and F3) to the nipple (I). Pass the wires carefully through each rod as you assemble.
-
Place the canopy (C) over rods (F) and thread the hanger ball (E) to rods (F). Please remove the nipple if installing with one 12” rod only.
-
Install the fixture body into the mounting plate (A) by tilting at a slight angle so that the hanger ball (E) slips into the mounting plate (A) as shown. Align the notch in the hanger ball (E) to the tab on the mounting plate (A) to prevent the fixture from turning. CONNECTING THE WIRES (Fig. 3)
-
At this point, connect the electrical wires as shown in figure 3, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the ground wires from the hanger ball and mounting plate to it. Otherwise, connect the ground wire from the hanger ball directly to the mounting plate ground wire and secure with the wire connectors provided. After wires are connected, tuck them carefully into the ceiling junction box. COMPLETING THE INSTALLATION (Fig. 1)
-
Align the canopy (C) over the mounting plate (A) and secure with screws (D).
-
Place the glass shade (J) over the socket (H) and secure with the screw shell (G).
-
Install the light bulb (K) in accordance with the fixture’s specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING!) (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
-
The dendrites of this lamp have the function of rotating a certain angle, customers can make their own adjustments. Your installation is now complete. Return power to the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION.
a. Hardware Bag:
A. Mounting Plate1
C. Canopy1
D. Screw2
E. Hanger Ball1
b. Hardware Bag:
F1. ROD 12″1
F2. ROD 12″2
F3. ROD 6″*1
LA-2881E
Documents / Resources
|
GEORGE KOVACS P1369-619 Nexpo 9 Light Coal Cluster Chandelier with Clear
Glass
Shades
[pdf] Instruction Manual
P1369-619 Nexpo 9 Light Coal Cluster Chandelier with Clear Glass Shades,
P1369-619, Nexpo 9 Light Coal Cluster Chandelier with Clear Glass Shades,
Chandelier with Clear Glass Shades, Clear Glass Shades
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>