anslut 019960 Spotlight Instruction Manual
- June 4, 2024
- anslut
Table of Contents
019960 Spotlight
Instruction Manual
Item no. 019960, 019961
Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions)
Jula reserves the right to make changes.
For the latest version of operating instructions, see
www.jula.com
SAFETY INSTRUCTIONS
- Only intended for indoor use.
- Switch off the power supply before installation.
- Do not connect the product to the mains when it is still in the pack.
- Do not look directly into the light source.
- Do not store the product in a damp or very cold/hot place, this can damage the electronics.
- The electronics in the product are sensitive to knocks and blows. Avoid dropping it.
- No parts of the product can be replaced or repaired. The whole product must be discarded if any part is damaged.
- The power cord on this product is not replaceable, if damaged discard the complete product.
- Do not use the product in a bathroom, or in damp or wet areas.
- The light source is not replaceable. Discard the product if the light source stops working.
- Switch off the product before cleaning.
- Only clean the product with a dry cloth. Do not use detergent or any other liquid to clean electrical parts.
- Do not touch the power cord or the plug with wet hands or wet parts of your body.
ELECTRICAL SAFETY
New installations and extensions to existing systems should always be carried out by an authorized electrician. If you have the necessary experience and knowledge (otherwise contact an electrician), you can replace power switches and wall sockets, fit plugs, extension cords, and light sockets. Incorrect installation can result in fatal injury and the risk of fire.
SYMBOLS
| Read the instructions.
---|---
| Only intended for indoor use.
| Protective earthing
| Non-replaceable light source.
| Non-replaceable actuator.
| Approved in accordance with the relevant directives.
| Recycle discarded products in accordance with local regulations.
TECHNICAL DATA
| Rated voltage | 230 V ~ 50 Hz |
|---|---|
| Output | 12 W |
| Luminous flux | 900 lm |
| Color temperature | 3000 K |
| Diffusion angle | 80° |
| Life span | 30000 h |
| Off/On | 15000 times |
| Safety class | I |
| Protection rating | IP20 |
This product contains a light source of energy efficiency class
INSTALLATION
- Make sure the power supply is disconnected.
- Carefully unpack the product.
- Mark out where to drill the mounting holes.
- Drill holes.
- Hang the cord on the hook.
- Open the junction box and connect the wires as shown in the figure.
- Replace the lid and screw in the screws.
- Reconnect the power supply.
FIG. 1
DISMANTLING
- Remove the top cover with a screwdriver.
- Undo the 2 screws on the sides.
- Release the soldered wire by melting the solder with a soldering iron.
- Remove the aluminum cover with a screwdriver.
- Release the soldered wire by melting the solder with a soldering iron.
- Done!
2022-04-04
© Jula AB
JULA AB, BOX 363, SE-532 24 SKARA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>