GEORGE KOVACS P5385-613 Charming 5-Light Polished Nickel Cage Pendant Light Installation Guide
- October 30, 2023
- GEORGE KOVACS
Table of Contents
INSTALLATION INSTRUCTIONS
Item#P5385-613 (New. 05/13/2022)
READ AND SAVE THESE INSTRUCTIONS
P5385-613 Charming 5-Light Polished Nickel Cage Pendant Light
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU
DISJONCTEUR.
PREPARATION (Fig. 1)
-
Shut off power at the fuse box or circuit breaker box an remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
ASSEMBLING THE FIXTURE (Fig.1) -
Slide cap (R) onto all thread (T) at the top of cluster (Q). Secure rod (O) onto all thread on cluster (Q). Secure fixture (S) to rod (O).
-
Slide cap (J) onto all thread (T) at the top of fixture (S). Secure rod (I) onto all thread (T) on top of fixture (S).
-
Determine the desired hanging height and thread rods (H1, H2 and H3) to all thread on rod (I). Then screw loop (G1) to rod (H1). Pass wires carefully through each rod as you assemble. Note: Remove the all thread, if installing with one 6” rod only.
-
Attach quick link (F) to loop (G1) and loop (G2) on canopy (C), carefully feeding wire through loop (G1), quick link (F), and loop (G2).
-
Attach circular strap (A) to the junction box (not included) using mounting screws (B). The side of the circular strap (A) marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2) -
Connect the electrical wires as shown in (Fig.2), making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to circular strap (A) using the ground screw provided.
-
Tuck the wire connectors neatly into the junction box.
COMPLETING THE INSTALLATION (Fig. 1) -
Slide canopy (C) over circular strap (A) and secure with screws (D).
-
Install (5) five candelabra base bulbs (K) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification—DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!) -
Alternate glass (L) and (Monto hooks (U), then hang hooks (M) to glass (L) and (N). Alternate again glass (N) and (L）onto hook (M) and repeat until complete.
Your installation is now complete. Return power to the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
a. Hardware Bag:
A. Circular Strap 1
B. Screws 2
C. Canopy with loop1
D. Mounting Screws2
E. Ground screw 1
F. Quick Link1
G1. Loop1
V. Wire connectors 3
b. Hardware Bag:
H1. ROD 12″1
H2. ROD 12″1
H3. ROD 12″1
I. ROD 6″1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>