C Cattleya CA2241-2W Light Matte Black Hardwired Outdoor Wall Lantern Sconce Instruction Manual
- October 30, 2023
- C Cattleya
Table of Contents
CA2241-2W Light Matte Black Hardwired Outdoor Wall Lantern Sconce
Product Information
The CA2241-2W is a light fixture that requires assembly and installation. Before installing, it is important to consult local electrical codes for wiring and grounding requirements. The fixture should not be installed in areas with jets of air conditions or strong airflow. The fixture comes with a mounting plate, ground wire, black wire, white wire, and decorative nuts. A bulb is not included and must be purchased separately.
Product Usage Instructions
- Before starting, ensure the power is turned off at the fuse or circuit box to avoid the risk of electrical shock.
- Attach the mounting plate to the outlet box using two mounting screws.
- Pull out the wires and grounding wire from the outlet box. Make wire connections using wire connectors according to local electrical codes.
- Attach the ground wire to the ground screw on the mounting plate with a machine screw.
- Connect the black wire from the fixture to the live wire in the outlet box and the white wire from the fixture to the negative wire in the outlet box using wire connectors.
- Caulk around the edge of the mounting plate to seal it against the wall or ceiling.
- Attach the decorative nuts to the fixture to secure it to the mounting plate.
- Install a bulb (not included) according to the instructions provided with the bulb.
- Turn on the power at the fuse or circuit box.
It is important to read and save these instructions for future reference.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER
WHILE INSTALLING OR SERVICING THIS FIXTURE
NOTES:
- Before installing, consult local electrical codes for wiring and grounding requirements.
- READ AND SAVE THESE INSTRUCTIONS.
To work properly.you should install this fixture NOT confront any jets of air conditions or strong airflow
-
Attach the mounting plate to the outlet box by using two mounting screws.
-
Pull out the wires and grounding wire from the outlet box. Make wire connections using the wire nuts, as follow:
Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap with the green grounding screw. Then connect it to the house grounding wire with the wire nut. Carefully put the wires back into the outlet box. -
Attach the back plate to the mounting plate by inserting the screws, then secure it with two nuts.
CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the wall surface to prevent water from seeping into the outlet box.
Turn on the power at fuse or circuit box.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>