George Kovacs P5441-077-L Modern Ice Modern Chrome LED Wall Sconce Instruction Manual
- October 30, 2023
- GEORGE KOVACS
Table of Contents
George Kovacs P5441-077-L Modern Ice Modern Chrome LED Wall Sconce Instruction Manual
PREPARATION
1. Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to misplace any small parts necessary for installation
MOUNTING THE FIXTURE (Fig. 1)
3. Secure mounting plate (B) to junction box (not included) using mounting screws (A) (Size: #8-32*1/2″L). The side of the mounting plate marked “GND” must face out.
CONNECTION THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (B) using the green screw provided.
5. Tuck wire connections neatly inside the junction box.
FINISHING THE INSTALLATION (Fig. 1)
6. Place fixture body (F) over mounting plate (B) and secure with screws (E).
7. Secure glass shade (G) to fixture body (F) with screws (H). Your installation is now complete. Return power to the junction box and test the fixture.
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician without cutting the wires and without damaging the decorative element to which the fixture is attached. See installation steps for more details (Fig. 3) Warning: Turn off power at the fuse box or circuit breaker before replacing LED module.
a. To remove the fixture from the wall, loosen screws (E) and remove the wire connectors (D). Remove fixture body (F) from mounting plate (B). Then place the fixture on a clear flat surface.
b. Loosen screws (H) and remove glass shade (G).
c. Loosen screws (I) and take out the silicone pad (J), disconnect the wires by pressing the connector using a pin (not included), then take out the LED module.
d. Reverse steps a-c for installing the new LED module. Note: The LED module should be provided by a specified supplier.
CAUTION / ATTENTION : When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base or fixture body only.
IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation. Dimmable with ELV and/or LED compatible wall dimmer switch.
Documents / Resources
|
George Kovacs P5441-077-L Modern Ice Modern Chrome LED Wall
Sconce
[pdf] Instruction Manual
P5441-077-L, P5441-077-L Modern Ice Chrome LED Wall Sconce, Modern Ice Chrome
LED Wall Sconce, Chrome LED Wall Sconce, LED Wall Sconce, Wall Sconce
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>