Adexa R10 Handmade Sink Topmount Instructions
- June 4, 2024
- Adexa
Table of Contents
Adexa R10 Handmade Sink Topmount
-
Measure the product size and calculate the hole size.
-
Draw the cutting line and cut the install hole;
- Fill in adhesive(glass cement)5-7mm outside the incision with a width of 3-7mm.
- Fill in adhesive(glass cement)5-7mm outside the incision with a width of 3-7mm.
-
Put the stainless steel sink in slowly.
-
Check again the position of the sink on the counter and glue appropriate glass cement at the edge of the sink.
- Fasten the clips to fix the sink. (Note: Clips are not necessity for thick-panel sink)
- Fasten the clips to fix the sink. (Note: Clips are not necessity for thick-panel sink)
Adexa Nordic AB
Website: adexanordic.se
Email: support@adexanordic.se
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>