Perrin Rowe 9.250120 Provence Sink Mixer with Lever Handles User Guide

: October 30, 2023
: PERRIN ROWE

Table of Contents

HOLE WIDESPREADS
IMPORTANT INFORMATION
- Preparation Check Box for Installer
PARS DESCRIPTION
BEFORE USE
CARE & MAINTENANCE
Documents / Resources

Perrin Rowe 9.250120 Provence Sink Mixer with Lever Handles

Congratulations on the purchase of your Perrin & Rowe Bathroom Product. Correctly installed and with sensible care, this product will give you many years of trouble free service.

HOLE WIDESPREADS

U.3712LS-2
U.3712LSP-2

Temp Range:
Min 1°C/34°F
Max 85°C/185°F

Recommended
Working Pressure:
Min 1bar/15psi
Max 5bar/75psi

Ideal performance obtained with equal hot & cold pressures.

IMPORTANT INFORMATION

Before you proceed… We recommend you engage the services of a registered plumber to install this product.

For ease of possible future servicing, we also recommend the fitting of conveniently placed isolating valves.

In addition to the guide below it is essential that the written information overleaf is carefully read and understood.

Preparation Check Box for Installer

Flush the plumbing system before installing the bathroom product.
Once unpacked remove large & small base seals, rosette, hood & lever, securing nut, clamp plate, pop-up and top waste ready for installation.

PARS DESCRIPTION

Secure spout with supplied Box Spanner.
Ensure all connections are firmly tightened

Sidevalve to be installed from underside of work surface as shown.

Ensure connection for flexible hose is facing towards spout.

Leave backnut at the bottom of valve body and place the valve body up through the work surface hole.

Before screwing down the hood & lever please make sure orientation of levers is correct. Slide the hood & lever over the top of valve body just enough to see if it is correctly orientated.
Correct orientation can be achieved by removing and turning the vernier insert.

Screw backnut up to the underneath of the work surface.

Connect flexible hose as shown.
Pars Description

Connect flexible hose as shown.
Connect HOT & COLD water supplies to the side valve inlets.
Ensure all connections are firmly tightened.

Adjusting Sink Waste

Ensure that pop-up shaft is in position alongside pop-up rod.
Shaft and rod can be cut if space is restricted.
Secure pop-up using clamp bracket.
Adjust position of clamp bracket to achieve maximum movement of pop-up shaft.
Place pop-up into waste and adjust movement of pop-up shaft.

Please Note: Ceramic disc valves are fitted as standard to this mixer. Flow from FULLY OFF to FULLY ON is achieved by rotating the handles a quarter turn.
Pars Description

BEFORE USE

Carefully check the installation for leaks.
If further building work is to be carried out in the vicinity, cover the tap with a plastic bag to avoid damaging the finish.
Please ensure that the installation complies with local plumbing codes.

CARE & MAINTENANCE

Wipe down after use to avoid water spotting and mineral build up.

Occasional cleaning with warm soapy water, followed by a polish with a soft cloth is all that is required to keep the plated finish in good condition.

Do not use proprietary abrasive liquids, powders, or pads to clean the shower. Do not use any products with ammonia bleach or limescale remover. You will damage the plated finish and void your guarantee.

Documents / Resources

| Perrin Rowe 9.250120 Provence Sink Mixer with Lever Handles [pdf] User Guide
9.250120 Provence Sink Mixer with Lever Handles, 9.250120, Provence Sink Mixer with Lever Handles, Mixer with Lever Handles, Lever Handles
---|---