PERRIN ROWE ROHA1635LMSTN2 Lonian Two Hole Bench Mounted Mixer Installation Guide
- June 8, 2024
- PERRIN ROWE
Table of Contents
The Triflow Kitchen Collection
Filter Installation Guide
ROHA1635LMSTN2 Lonian Two Hole Bench Mounted Mixer
Temp Range:
Max 85°C/185°F
Recommended
Working Pressure:
Min 1.7bar/25psi
Max 5bar/75psi
Please register your new product.
Complete the enclosed registration card, or call Toll free on 800.777.9762.
Turn on the main supply valve.
Run the filtered water for 2 minutes to flush the system, and carefully check
the system for leaks. The system is now ready for use.
For optimum filter performance when using the U.1802 filter cartridge use the
stop valve to set a water flow of 0.4gpm to 0.5gpm max.
To Winterize the Unit
Shut off mains supply. A stop valve was supplied with the system for this
purpose, and will be located on the adjacent pipe work. If you plan to be away
from home for extended periods, carry out the procedures above, to prevent
the risk of freezing. Freezing will invalidate the warranty.
Turn the filtered lever on the faucet to the on position. This will confirm
the water supply is off, and release the pressure in the system.
Pre-filter Installation
If installing a Pre-filter follow steps 1-3 for the second bracket taking into account the hose length supplied from the Pre-filter to the filter.
Tighten the hoses from the stop valve to the housings following the flow of the water shown on the cap. When installing the Pre-filter the system flows from the stop valve to the Pre-filter and on to the filter housing and then up to the filter tap.
IMPORTANT NOTES
Do not use with water, that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system. Systems certified
for cyst reductions may be used on disinfected waters that may contain
filterable cysts.
Please ensure that the installation complies with applicable State & local
plumbing codes. System is to be supplied with cold water only.
CARE & MAINTENANCE
Wipe down after use to avoid water spotting and mineral build up.
The Perrin and Rowe Collection
Filter Installation Guide
Congratulations on the purchase of your Perrin and Rowe/Triflow filtration
Product. Correctly installed and with sensible care, this product will give
you many years of trouble free service.
IMPORTANT INFORMATION
These are instructions for Triflow filters and the optional add on pre-filter
version of the model you are installing. Please read carefully to ensure
correct installation.
Before you proceed… We recommend you engage the services of a registered
plumber to install this product.
In addition to the guide below it is essential that the written information
overleaf is Carefully read and understood.
Preparation for Installer Flush the plumbing system before Ensure you have the
correct fittings to connect installing the Kitchen product. to the filter
faucet
Install the supplied stop valve in an easily accessible area to allow access
to turn off the water supply in the future, for servicing and cartridge
replacement.
Position the filter housing leaving room around it for future access and
cartridge replacement. Mark the screw holes ready for pilot holes. Leave room
for the Pre-filter housing if necessary.
Drill the pilot holes and screw the filter housing bracket in position. Making sure to keep as level as possible.
Tighten the hoses from the stop valve to the housings following the flow of
the water shown on the cap.
If installing a Pre-filter the system flows from the stop valve to the Pre-
filter and on to the filter housing and then up to the filter tap.
With the supplied connector kit connect the hose from the filter housing to the filter tap using one of the connectors.
3 Parker
Irvine, CA 92618
800-777-9762
www.rohlhome.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>