Newell BP-4CH Four Channel Charger for V Mount Batteries User Manual

: October 30, 2023
: Newell

Table of Contents

Newell BP-4CH Four Channel Charger for V Mount Batteries
SAFETY INSTRUCTIONS
PRODUCT DESCRIPTION
PRODUCT FEATURES
USAGE
- LED State Indication
SPECIFICATION
WASTE MANAGEMENT
WARRANTY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Newell BP-4CH Four Channel Charger for V Mount Batteries

SAFETY INSTRUCTIONS

Do not charge batteries that are not intended for this device, as this may damage the battery and lead to leakage and explosion.
Do not drop the unit or place heavy objects on it.
Store in a dry, cool, and ventilated place. Do not expose the device to moisture or rain.
Keep away from heat sources and places of high temperature.
Do not expose to direct sunlight.
The device can operate in the temperature range 0°C – 40°C.
Do not leave it unattended when charging.
Remove the batteries from the charger when not in use.
Keep out of reach of children.
The slight warming up of the device is normal.
If you notice smoke or a strange smell coming from the device, immediately disconnect the power. Do not disassemble. Disassembling the unit will void the warranty. If there are problems with the lamp, bring it to an authorized service center.

PRODUCT DESCRIPTION

AC Power
Charging State LED
Battery Online LED
Discharging State LED
DC output (XL connector pin female)
Support Stand
Battery Release Lever
Charging Connector
AC Power Switch
AC Socket
Radiator Fan

PRODUCT FEATURES

This charger can charge V-mount batteries with a nominal voltage of 14.4V/14.8V.
No change is required at 100-240V.
Quick charge for 1pcs or 2pcs lithium-ion batteries, sequential nominal charge for 3pcs or 4pcs lithium-ion batteries.
Equipped with an XLR 4P terminal interface, it can be used as a DC power supply for example cameras.
A fully charged lithium-ion battery can be used as backup power

USAGE

When used as a charger

Install the battery on the charger as shown.
After connecting the battery, the charger can charge the battery, and the corresponding indicator will light up. If the corresponding indicator is not lit, please check the connection between the charger and the battery.
After charging to 85%, the charging indicator, light will turn from red light to green light, and when the battery will be fully charged, the light will go out.
After fully charged, the corresponding indicator light is off and charging is completed.
When removing the battery from the charger, firmly press the release lever while lifting the battery straight up.

For safety, please do not move the charger at will when it is working.

When used as with DC output
When the power AC is off batteries can be used as backup power and supply sequential DC output by XL 4P connector. Connect with XLR cable to supply power for camcorders, etc.

The charging function and DC output function cannot be used at the same time:

While the BP-4CH charger operates as a charger, the DC output function is disabled. While the DC output is in operation, charging is disabled.
Please make sure to check the power consumption of the connected device prior to using the BP-4CH DC output before use.

Operation Procedure
Tilt the loader to the side and tilt the support until it locks into place.

AC Power Cable connection
Connect the AC cable with the BP-4CH charger and make it plugged in, then turn the switch to the “I position as shown.

Please place the charger at ventilate location, do not cover the window of the radiator fan.

LED State Indication

SPECIFICATION

Input	tOO 240V 50/60Hz 3A Max
DC Output	t6.SV=4,SA

t6.8V=3A” 1-2

{charging 1 or 2 pcs batteries at the same time)

16.8V=2A • 3-4

{charging 3 or 4 pcs batteries at the same time)

Operating temperature| onC-40 C
Operating humidity| 20%-90% RH
Dimension| 265x 103 x 223mm {L x W x H)
Weight| 3300g

The manufacturer reserves the right to change the information contained in this manual without prior notice.

WASTE MANAGEMENT

The crossed-out trashcan symbol means that waste electrical and electronic, batteries, and packaging must not be placed with other household waste. They must be handed over to a separate waste collection system.