COEFFICIENT Cycling RR Bar Grips for Cycles Installation Guide
- June 12, 2024
- COEFFICIENT Cycling
Table of Contents
RR Bar Grips for Cycles
Installation Guide
Coefficient RR Grips Installation Guide
Prior to installation, sillily unwrap your bar tape to expose the 1..0 at the
shoulder’the place where most people terminate their bar tape.
Thoroughly clean the bar using soap and water, then we with alcohol. Now bar
to thoroughly dry.
The grips include a spit release kner on the backside to assist with
positioning.
To figure out LvsR side, simply lay them Flat on the table. You’ll see “thumb
protrusions” on both sides pointing inward and upward When plachg on bar, the
outside edge of the grips align with the bar logo and size stamps.
For inside alignment, set it up as shown in the ilustration. Once mounted,
push frmly on the grips to secure.
Re-wrap your bar tape so it sightly overlaps the grips. Note: IF your bar is
not perfectly dean before mounting grps wi detach overnight.
To remedy this, try and apply extra pressure on the gips so they hold more
Ermly in place.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>