Rondish TM-12 Cordless Pad Transmitter Instruction Manual
- June 10, 2024
- Rondish
Table of Contents
Rondish TM-12 Cordless Pad Transmitter
Product Information: TM-12, TM-12B Wireless Transmitter
The TM-12, TM-12B is a wireless transmitter designed to monitor the status of pads, time pads, and floor mats. It supports learn code transmission, tracking transmission, and pad/mat status change alarm/reset transmission. The device also includes bed/wheelchair product type information and battery low detection.
Features
- Learn code transmission
- Tracking transmission
- Pad/mat status change alarm/reset transmission
- Bed/wheelchair product type information
- Battery low detection
Specifications
| Model No. | TM-12, TM-12B |
|---|---|
| Battery Type | Lithium Manganese Dioxide /CR2477 x 2 |
| Battery Life | Min. 1 year (standby) |
| Operation Frequency | 433.92MHz |
| Modulation Type | ASK |
| ID Code Combinations | 0001 to 4095 |
| Supported Pad Types | Bed, Chair, or Floor Mat (NGM-21, NGM-41) |
| Nominal Range with CBM | 30M (open area) |
| To Work with the Type of Monitors Individually | N/A |
| Operation Voltage | N/A |
| Housing Dimensions | N/A |
| Net Weight (with batteries) | N/A |
| Operating Temp | N/A |
| Approvals | N/A |
Product Usage Instructions
- Learn Code Transmission: The TM-12, TM-12B allows for two ways to generate learn codes:
- Turn ON the power of TM-12, TM-12B to trigger learn code transmission. The status LED will stay on for about 1s and 3s for normal and long delay of alarm debounce.
- Press the pad about 1 sec and then release it.
- Tracking Transmission: The device transmits tracking codes about every 41s. The tracking code includes information about the pad/mat and battery condition. The LED will flash once with tracking transmission.
- Pad/Mat Status Change Alarm/Reset Transmission: The device sends bursts of transmission for alarm/reset purpose:
- After the pad is pressed and then released.
- After the floor mat is pressed.
- Battery Low Detection: The device enters battery low stage under the following conditions:
- Low Cell battery voltage.
- When the set operation days count down to zero.
After the battery low stage lasts for 7 days, the device will be locked, and all function will be disabled, even if batteries are replaced.
- Coin/Button Cell Battery Safety: This product contains a coin / button cell battery. If the coin / button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and
keep it away from children. If you think batteries might have been swallowed
or placed inside any part of the body, seek immediate medical attention.
The TM-12, TM-12B is a wireless transmitter that supports pad, time pad, and
floor mat. It is designed to monitor the status of these devices. The
following features are available:
-
Learn code transmission.
The device allows for two ways to generate learn codes:- Turn ON the power of TM-12, TM-12B to trigger learn code transmission. The status LED stay on for about 1s and 3s for normal and long delay of alarm debounce.
- Press the pad about 1 sec and then release it.
-
Tracking transmission.
The device transmits tracking codes about every 41s. The tracking code includes information about the pad/mat and battery condition. The LED will flash once with tracking transmission. -
Pad/mat status change alarm/reset transmission
The device sends bursts of transmission for alarm/reset purpose:- After the pad is pressed and then released.
- After the floor mat is pressed
-
Bed/Wheelchair Product type
Every transmission contains the product type of either bed or wheelchair. -
Battery Low detection
The device enters battery low stage under the following conditions:
-
* Low Cell battery voltage.- When the set operation days count down to zero.
After the battery low stage lasts for 7 days, the device will be locked, and all function will be disabled, even if batteries are replaced.
Notice:
Any changes or modifications not expressly approved by the party responsible
for compliance could void your authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced RF technician for help.
This product contains a coin / button cell battery. If the coin / button cell
battery is swallowed, it can cause severe internal burns in just 2 hours and
can lead to death. Keep new and used batteries away from children. If the
battery compartment does not close securely, stop using the product and keep
it away from children.
If you think batteries might have been swallowed or place inside any part of
the body, seek immediate medical attention.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>