MGC ANC-4000 Audio Network Controller Board Instruction Manual

ANC-4000
Audio Network Controller Board
Installation Manual

Module Mounting Locations

The ANC-4000 Audio Network Controller board may be mounted in two locations. One mounting location is in Slot 1 of the QMB-5000N backplane. The ANC-4000 is mounted using 7 screws to the backplate which is included with the QMB-5000N. Refer to Figure 1 below.
The other position is on the mounting plate BK-137 with the TNC-5000 (if used) mounted over the ANC-4000. Both are then mounted into a BB-5008 or BB-5014 backbox as shown in Figures 2, 3 and 4.
Mechanical Installation of the ANC-4000 within the BB-5008 and BB-5014

A. Mount ANC-4000 (and TNC-5000 if used) on Mounting Plate
The mounting plate is included with FX-4009-12N (MMX-4009-12N).
Note: The pin must be on the bottom and the LEDs for both boards must be on the top.

B. Mount Assembly beside Main Fire Alarm Board

C. Final Position of ANC-4000, TNC-5000, Mounting Plate
Note: The pin must be on the bottom and the LEDs for both boards must be on the top. Main fire alarm board

DIP Switch Setting for SW1

Addresses available for the ANC-4000 per node are set as per the table below:
Table 1 ANC-4000 Board, Address Setting (DIP SWITCH SW1)

Refer to Network Fire Alarm manual as to whether addresses 5. 6 and 7 are available.
5| OFF| OFF| OFF| OFF| OFF| ON| OFF| ON
6| OFF| OFF| OFF| OFF| OFF| ON| ON| OFF
7| OFF| OFF| OFF| OFF| OFF| ON| ON| ON

ANC-4000 Audio Network Controller Module

Note: Revision F and later of MD-1016 (the circuit board in the QMP- 5101N(V)) has a gain of 10x to increase the overall signal-to-noise performance. Therefore, the ANC-4000 must use the 1x gain setting by opening jumpers JW7 and JW8.

ANC-4000 Wiring$

Audio Paging Bus Wiring

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>