beckett Luminarias Reflectors Solar Submersible Light Set Instructions
- June 10, 2024
- beckett
Table of Contents
beckett Luminarias Reflectors Solar Submersible Light Set
Product Information Solar Submersible Light Set
The Solar Submersible Light Set is a set of LED lights that are powered by solar energy. These lights are designed to be submersible and come equipped with luminarias reflectors. The solar panel is responsible for charging the rechargeable batteries that power the lights.
Product Usage Instructions
- Choose a location for the Solar Submersible Light Set that receives full and direct sunlight, with minimal interference from other light sources and not installed in a shady area.
- For first-time use, switch the light on and allow it to charge in full sunlight for 8-12 hours to allow the rechargeable batteries to reach maximum capacity. Note that the lights may have a protective film over the solar panel that must be removed prior to use.
- Optional installation: If desired, drill three small holes and insert three wall anchors on a solid surface. Place the solar panel on the solid surface and line up the screws with the wall anchors. Tighten the screws until secure.
- Slide part A over part B and insert the stake (part C) into the bottom of part B. Carefully insert the complete assembly into the desired surface.
For best performance, this solar light should be installed in a location with full and direct sunlight, in a location with minimal interference from other light sources and not installed in a shady area.
FOR FIRST TIME USE
SOLAR LIGHT NEEDS TO CHARGE IN FULL SUNLIGHT FOR 8-12 HOURS WITH THE SWITCH IN THE “ON” POSITION TO ALLOW THE RECHARGEABLE BATTERIES TO REACH MAXIMUM CAPACITY. LIGHTS MAY HAVE A PROTECTIVE FILM OVER THE SOLAR PANEL. THIS MUST BE REMOVED PRIOR TO USE.
ASSEMBLY
Slide (Part A) over (Part B). Insert ground stake (Part C) into the bottom of (Part B). Carefully insert the complete assembly into the ground where desired
Optional installation : Drill 3 small holes and insert 3 wall anchors on solid surface. Place solar panel on the solid surface and line up screws with wall anchors. Tighten screws until secure.
NON-REPLACEABLE BATTERIES
WARNING
Do not dispose of Ni-CD batteries in municipal waste stream or by fire as
batteries may explode. Do not open, short circuit, or mutilate batteries.
Dispose of batteries in accordance with Local, State, and Federal regulations.
© 2023 Beckett Corporation 3250 Skyway Circle N. Irving TX 75038
- www.BeckettUS.com
- Toll Free : 1-866-466-4319
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>