GE Candle Battery Instructions

GE Candle Battery

Product Information

This product is an indoor-use candle that creates a warm and cozy ambiance with its light. It is powered by (2) AA Alkaline batteries and features an ON/OFF switch for easy control. The candle is designed to be used with caution, and certain usage and care instructions should be followed to ensure optimal performance and longevity.

Usage Instructions

1. Do not expose the candle to moisture.
2. This product is not intended for outdoor use.
3. Replace only with (2) AA Alkaline batteries.
4. Replace all batteries of a set at the same time.
5. Clean the battery contacts and those of the device before battery installation.
6. Install (2) AA Alkaline batteries as shown in FIG.1.
7. Remove batteries from the product when not in use for an extended period of time.
8. Remove used batteries promptly.
9. To turn ON/OFF the light, twist the bulb clockwise or counter-clockwise as shown in FIG.2.

Battery Installation Instructions

To install batteries:

1. While holding the candle with one hand, CAREFULLY twist the bulb counter-clockwise with the other hand to open the battery cavity.
2. Insert (2) AA Alkaline batteries, positive (+) end first.
3. Replace the bulb by twisting clockwise.

Note : While holding the candle base with one hand, twist the bulb clockwise with the other hand to turn the light ON. Twist bulb counter- clockwise to turn light OFF.

Troubleshooting

If the product does not light, consider the following possible causes and corrective actions:

2. Batteries assembled incorrectly.
3. Low power or dead batteries.| 1. Rotate bulb clockwise in the candle.
2. Follow battery installation procedure.
3. Replace with new batteries.

Note : This product is a trademark of General Electric Company and is under license by Nicolas Holiday Limited. Made in China. Printed in China.

USE AND CARE INSTRUCTIONS

The instructions below should be followed for proper use and care of this product:

1. Do not expose candle to moisture.
2. Not for outdoor use.
3. Replace only with (2) AA Alkaline batteries.
4. Replace all batteries of a set at the same time.
5. Clean the battery contacts and also those of the device prior to battery installation.
6. Install (2) AA Alkaline batteries as shown(FIG.1).
7. Remove batteries from product when not in use for an extended period of time.
8. Remove used batteries promptly.
9. Turn light ON/OFF as shown(FIG.2).

WARNING : DO NOT expose batteries to fire, attempt to recharge, use different sizes or install backwards. DO NOT mix old and new batteries. DO NOT mix Alkaline,Standard (Carbon-Zinc) , or Rechargeable (Nickel Cadmium) batteries. Never handle damaged or leaking batteries-may result in burn injuries or cause serious internal injuries if swallowed. Obtain medical attention immediately. Misuse can cause battery to overheat, rupture, leak or explode, resulting in personal injury and property damage. KEEP AWAY FROM CHILDREN.OL-2 This Class B digital apparatus complies with Canadian ICES-005(B) / NMB-005(B).
Modifications not approved by the party responsible for compliance could void user’s authority to operate the equipment

FCC

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

For indoor use only
GE is a trademark of General Electric Company and is under license by Nicolas Holiday Limited
Made in China
©2022 Nicolas Holiday Ltd. 204 Spring Hill Road Trumbull, CT 06611 9F., No. 37, Guangfu North Rd. Taipei, Taiwan 10560 All rights reserved.
For additional GE Holiday Lighting information, please visit us on the web at www.geholidaylighting.com
Printed in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>