Tala BRAS-PAP-01-EU Plug In Pendant Installation Guide
- June 11, 2024
- TALA
Table of Contents
BRAS-PAP-01-EU Plug In Pendant
Installation Guide
BRAS-PAP-01-EU Plug In Pendant
Thoughtful lighting, responsibly designed in London. Thank you for making the
switch to Tala.
Discover the full Tala family at tala.co.uk
BEFORE STARTING
Please read instructions thoroughly before installation and keep them for
future reference. Please take extreme care when dealing with electrical
equipment.
IMPORTANT
Bulb must be installed in fixture before turning on.
WARNING
Ensure power is turned OFF before inserting plug. Incorrect assembly may
result in risk of fire or electric shock.
CARE AND CLEANING
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as
these will damage the finish of the product.
WARRANTY AND AFTER-CARE
This product has a two-year warranty. If there appears to be a functional
defect with the product during this time, please contact our team at
customerservice@tala.co.uk.
Please note, the flexible cable attached to this luminaire cannot be replaced;
if the cable is damaged, recycle the luminaire and seek a replacement.
| SKU – GRAP-PAP-01-EU | SKU – OAK-PAP-01-EU |
|---|---|
| SKU – BRAS-PAP-01-EU | SKU – WALT-PAP-01-EU |
FOR INDOOR USE ONLY
This symbol indicates that electrical and electronic equipment (WEEE) should
not be mixed with general household waste. For recovery and recycling, please
take this product to a designated collection point where it will be accepted
free of charge. Many retailers offer this in-store. Disposing of this product
correctly will help save valuable resources and prevent any potential negative
effects on human health and the environment.
Plug-in Pendant – Provided Components A x1 Cord with Dimmer Dial and US
plug x1 Pre-assembled Tala Pendant Oak, Walnut, Brass or Graphite
B C x2 Insulation tubes Adjustable – position in-line with nodes
D x2 Ceiling Nodes Consisting of 2 x caps and 2 x bases
E x1 Fixing Pack (Only use if suitable for ceiling type)
F x1 EU to UK Plug STEP 1
Decide on your layout for the Plug-in pendant, some examples are shown below.
Ensure you have enough cable for your desired layout before setting up the
pendant, and the dimmer is always accessible STEP 2
Attach Node base D1 to ceiling. Always choose screws and plugs that are
appropriate for the ceiling material.
Ensure the Node channel runs parallel with the planned cord direction.
STEP 3
Position the Cord into the Node A base at the desired points forD1 your
layout.
Slide the Insulation TubesC into the centre of the Ceiling Nodes.
Screw the Node cap D2 onto the Node base clockwise until secure. Do not over
tighten. STEP 4
Insert your bulb into the pendant, rotating clockwise until tight. Take care
not to tighten too much to avoid breakage. STEP 5 – FOR UK ONLY
Push the EU plug into the UK Adapter untill it clicks in and the plug does not
come loose. STEP 6
Insert the lamp plug into your chosen wall socket, making sure the power is
switched off.
STEP 7
Switch the power on and rotate the dial on your dimmer until the bulb lights
up. Adjust the dimmer for your desired light output.
Join the Community
Instagram: @tala | Facebook: talaHQ | Pinterest: TalaLED | Tag: lighttoliveby
Tala Studios, 25B Vyner Street, London E2 9DG |
hello@tala.co.uk
Tala Europe B.V, Bertus Aafjeshove 40, Nieuwegein 3437JN, Netherlands
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>