VISUAL COMFORT Co 4468102-112 Alvin Vanity Light Installation Guide

VISUAL COMFORT Co 4468102-112 Alvin Vanity Light

Product Information

The Alvin Wall is a lighting fixture suitable for damp locations. It is available in both incandescent and LED versions. The incandescent version can be dimmed with a standard incandescent dimmer, while the LED version can be dimmed with a LED dimmer. The fixture should be installed using an NEC compliant junction box and must be installed by a person familiar with the construction and operation of the product and the hazards involved. The product has a mounting plate, socket, shade collar nut spacer, shade tool, and cap nut for easy installation.

Product Usage Instructions

1. Secure the mounting plate to the junction box.
2. Connect the fixture to a suitable ground in accordance with local electrical codes.
3. Connect the white fixture wire to the neutral power line wire with a wire nut.
4. Connect the black fixture wire to the hot power line wire with a wire nut.
5. Neatly place the wires into the junction box, place the fixture onto the mounting studs, and secure it in place by screwing the cap nuts onto the studs.
6. Place the shade, then the spacer on to the socket and secure them in place by screwing the shade collar nut onto the socket using the shade tool. Do not over tighten. If necessary, repeat for all the other shades.
7. Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage Information.

Note : Consult lamp manufacturer for additional information.

GENERAL PRODUCT INFORMATION

These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for damp locations. Incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information. This instruction shows a typical installation

CAUTION – RISK OF FIRE
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors

SAVE THESE INSTRUCTIONS!

Install the Fixture

1. Secure the mounting plate to the junction box.
2. Connect the fixture to a suitable ground in accordance with local electrical codes.
3. Connect the white fixture wire to the neutral power line wire with a wire nut.
4. Connect the black fixture wire to the hot power line wire with a wire nut.
5. Neatly place the wires into the junction box, place the fixture onto the mounting studs, and secure it in place by screwing the cap nuts onto the studs.
6. Place the shade, then the spacer on to the socket and secure them in place by screwing the shade collar nut onto the socket using the shade tool. Do not over tighten. If necessary, repeat for all the other shades.
7. Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage Information

©2022 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.

7400 Linder Ave., Skokie, IL 60077

• T 847.410.4400
• F 847.410.4500
• www.generationlighting.com

References

• Generation Lighting Collection | Visual Comfort & Co.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>