WYNDHAM COLLECTION WC-1111-60-SGL D x 35 in. H Single Bath Vanity in Dark Gray Installation Guide
- June 4, 2024
- WYNDHAM COLLECTION
Table of Contents
WC-1111-60-SGL
Installation Guide
- Prior to installation please check received items against the “Packing List”. Please report any missing items to your retailer immediately.
- Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards.
- Professional installation is recommended.
- Please install it on a level surface. If the minor door and drawer alignment is required, please follow the easy directions below.
- Backsplash comes in two pieces.
PACKING LIST
(Not all components may be included, depending upon your purchase)
| 
---|---
|
HOW TO ADJUST HINGES (if required)
REQUIRED TOOLS NOT IN THE BOX
INSTALLATION INSTRUCTIONS
-
Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not overapply. Allow drying for 24 hours for proper curing.
-
Install the mirror: use a pencil to mark the placement of the screw holes on the wall, drill the holes and insert the plastic wall anchors.
-
Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror – approx 1/4” 1/2”.
-
Remove the handles from inside the cabinet doors and drawers and reinstall them on the outside. Do not over-tighten when reattaching.
HOW TO ADJUST DRAWER SLIDES (if required)
Up and Down Adjustment
|
Side Adjustment
|
Depth Adjustment
---|---|---
| 
| 
https://www.wyndhamcollection.com/3dslides
Scan the QR code with your phone to watch detailed
video instructions or visit
www.wyndhamcollection.com/3dslides
Backboard Cutouts
*Note: All measurements are ± 1/4”.
Electrical Outlets with Charging Hub
Easy to install
Long 5-foot plug-in cord
2 electrical outlets, 125V 15A
Tamper Resistant (TR) outlets
Power reset switch
2 USB ports, 5V 2.1A Max
Use with ground-fault circuit interrupter (GFCI) outlets only
Residential use only
Follow all applicable electrical codes
ETL Listed
Conforms to UL Standard 962A
Certified to CAN/CSA Standard C22.2 No. 308
