WYNDHAM COLLECTION Double Vanity with Optional Carrara Marble Counter Installation Guide
- June 4, 2024
- WYNDHAM COLLECTION
Table of Contents
- WYNDHAM COLLECTION Double Vanity with Optional Carrara Marble Counter
- PACKING LIST
- HOW TO ADJUST HINGES (if required)
- REQUIRED TOOLS NOT IN BOX
- INSTALLATION INSTRUCTIONS
- HOW TO ADJUST DRAWER SLIDES (if required)
- Backboard Cutouts
- Electrical Outlets with Charging Hub
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
WYNDHAM COLLECTION Double Vanity with Optional Carrara Marble Counter
- Prior to installation please check received items against the “Packing List”.
- Please report any missing items to your retailer immediately.
- Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight and chemical hazards.
- Professional installation recommended.
- Please install on a level surface. If minor door and drawer alignment is required, please follow the easy directions below.
- Backsplash comes in two pieces.
PACKING LIST
(Not all components may be included, depending upon your purchase)
HOW TO ADJUST HINGES (if required)
REQUIRED TOOLS NOT IN BOX
INSTALLATION INSTRUCTIONS
- Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not over apply. Allow to dry 24 hours for proper curing.
- Install the mirror: use a pencil to mark the placement of the screw holes on the wall, drill the holes and insert the plastic wall anchors.
- Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror – approx 1/4” -1/2”.
- Remove the handles from inside the cabinet doors and drawers and reinstall on the outside. Do not over tighten when reattaching.
HOW TO ADJUST DRAWER SLIDES (if required)
Scan the QR code with your phone to watch detailed video instructions or visit www.wyndhamcollection.com/3dslides
Backboard Cutouts
Electrical Outlets with Charging Hub
- Easy to install
- Long 5 foot plug in cord
- 2 electrical outlets, 125V 15A
- Tamper Resistant (TR) outlets
- Power reset switch
- 2 USB ports, 5V 2.1A Max
- Use with ground-fault circuit interrupter (GFCI) outlets only Residential use only
- Follow all applicable electrical codes
- ETL Listed
- Conforms to UL Standard 962A
- Certified to CAN/CSA Standard C22.2 No. 308
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>