WYNDHAM COLLECTION WC-1111-30-SGL 30 Inch Single Vanity with Optional Cultured Marble Counter Installation Guide
- June 11, 2024
- WYNDHAM COLLECTION
Table of Contents
WYNDHAM COLLECTION WC-1111-30-SGL 30 Inch Single Vanity with Optional
Cultured Marble Counter
Product Information
The product is a cabinet with a counter and sink, as well as a mirror and screws for the mirror. The cabinet should be protected from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards. Professional installation is recommended, and the cabinet should be installed on a level surface. The product comes with a packing list, but not all components may be included depending on the purchase. The product also includes electrical outlets with a charging hub that is easy to install and has a long 5-foot plug-in cord. The charging hub has 2 electrical outlets, 125V 15A Tamper Resistant (TR) outlets, a power reset switch, and 2 USB ports, 5V 2.1A Max. It should only be used with ground-fault circuit interrupter (GFCI) outlets and is for residential use only.
Product Usage Instructions
- Check received items against the packing list. Report any missing items to the retailer immediately.
- Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight, and chemical hazards.
- Professional installation is recommended.
- Install the cabinet on a level surface.
- If minor door and drawer alignment is required, follow the easy directions below:
- Adjust height
- Adjust laterally
- Adjust depth
- To install the product:
- Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not over apply. Allow to dry for 24 hours for proper curing.
- Draw a horizontal line and mark the screw position for the mirror.
- Install the mirror: use a pencil to mark the placement of the screw holes on the wall, drill the holes, and insert the plastic wall anchors.
- Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror – approximately 1/4-1/2 inch.
- Remove the handles from inside the cabinet doors and drawers and reinstall on the outside. Do not over tighten when reattaching.
-
Prior to installation please check received items against the “Packing List”.
Please report any missing items to your retailer immediately. -
Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight and chemical hazards.
-
Professional installation recommended.
-
Please install on a level surface. If minor door and drawer alignment is required, please follow the easy directions below.
PACKING LIST
(Not all components may be included, depending upon your purchase)
HOW TO ADJUST HINGES (if required)
REQUIRED TOOLS NOT IN BOX
INSTALLATION INSTRUCTIONS
-
Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not over apply. Allow to dry 24 hours for proper curing.
-
Install the mirror: use a pencil to mark the placement of the screw holes on the wall, drill the holes and insert the plastic wall anchors.
-
Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror – approx 1/4” -1/2”.
-
Remove the handles from inside the cabinet doors and drawers and reinstall on the outside. Do not over tighten when reattaching.
HOW TO ADJUST DRAWER SLIDES (if required)
Up and Down Adjustment
Side Adjustment
Depth Adjustment
Scan
the QR code with your phone to watch detailed video instructions or visit
www.wyndhamcollection.com/3dslides
Backboard Cutouts
Note: All measurements are ± 1/4”.
Electrical Outlets with Charging Hub Easy to install
Long 5 foot plug in cord
2 electrical outlets, 125V 15A
Tamper Resistant (TR) outlets
Power reset switch
2 USB ports, 5V 2.1A Max
Use with ground-fault circuit interrupter (GFCI) outlets only
Residential use only
Follow all applicable electrical codes
ETL Listed
Conforms to UL Standard 962A
Certified to CAN/CSA Standard C22.2 No. 308
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>