WYNDHAM COLLECTION WC-4141-60-DBL 60 Inch Double Vanity Installation Guide
- June 13, 2024
- WYNDHAM COLLECTION
Table of Contents
WC-4141-60-DBL 60 Inch Double Vanity
Installation Guide
WC-4141-60-DBL 60 Inch Double Vanity
- Prior to installation please check received items against the “Packing List”. Please report any missing items to your retailer immediately.
- Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight and chemical hazards.
- Professional installation recommended.
- Please install on a level surface. If minor door and drawer alignment is required, please follow the easy directions below.
- Backsplash comes in two pieces.
PACKING LIST
(Not all components may be included, depending upon your purchase) HOW TO ADJUST HINGES (if required) REQUIRED TOOLS NOT IN BOX
INSTALLATION INSTRUCTIONS
- The handles are safely stored for transport in a box inside of the cabinet. Look inside the vanity for the box with your handles.
- Unpack the handles and install them on the vanity. Do not over tighten when attaching.
- Short screws are for the door handles and long screws are for the drawer handles.
- Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not over apply. Allow to dry 24 hours for proper curing.
- Install the mirror: use a pencil to mark the placement of the screw holes on the wall, drill the holes and insert the plastic wall anchors.
- Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror – approx. 1/4” – 1/2”.
HOW TO ADJUST DRAWER SLIDES (if required) Scan the QR code with your phone to watch detailed video instructions or visit www.wyndhamcollection.com/3dslides
https://www.wyndhamcollection.com/3dslides
**Backboard Cutouts![WYNDHAM COLLECTION WC-4141-60-DBL 60 Inch Double Vanity
-
Backboard Cutouts](https://manuals.plus/wp-content/uploads/2023/10/WYNDHAM- COLLECTION-WC-4141-60-DBL-60-Inch-Double-Vanity-Backboard-Cutouts.jpg) *Note: All measurements are ± 1/4”.
Electrical Outlets with Charging Hub
**-
Easy to install
-
Long 5 foot plug in cord
-
2 electrical outlets, 125V 15A
-
Tamper Resistant (TR) outlets
-
Power reset switch
2 USB ports, 5V 2.1A Max -
Use with ground-fault circuit interrupter (GFCI) outlets only
-
Residential use only
-
Follow all applicable electrical codes
-
ETL Listed
-
Conforms to UL Standard 962A
-
Certified to CAN/CSA Standard C22.2 No. 308
-
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>