DrBrown s AC219-INTL Bottle Sterilizer and Dryer Instruction Manual

: June 4, 2024
: DrBrown s

Table of Contents

DrBrown s AC219-INTL Bottle Sterilizer and Dryer
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
PARTS
TO USE
over view
TO CLEAN THE APPLIANCE
WARRANTY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

DrBrown s AC219-INTL Bottle Sterilizer and Dryer

READ AND SAVE THESE INSTRUCTIONS

WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury. Failure to operate this Product in a safe and responsible manner could result in injury or damage to the product or other property. This product is not intended for use by children. Do not attempt disassembly or use with incompatible components. This manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings in the manual, prior to setup or use, in order to operate correctly and avoid damage or serious injury.

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS BEFORE USING THIS APPLIANCE WHEN USING ELECTRICAL APPLIANCES, PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK AND INJURY TO PERSONS, INCLUDING THE FOLLOWING:

Do not touch hot surfaces. Use handles or knobs.
To protect against electrical shock, do not immerse cord or plug in water or other liquids.
Close supervision is necessary when any appliance is used near children.
This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts.
Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair or adjustment.
The heating element surface is subject to residual heat after use.
The use of accessory attachments not recommended by Handi-Craft Company and may cause injuries.
Do not use outdoors.
Do not let cord hang over edge of table or counter or touch hot surfaces.
Do not place on or near a hot gas or electric burner or in a heated oven.
Extreme caution must be used when moving an appliance containing hot liquids.
To operate, plug cord into wall outlet. To disconnect, press “power” button then remove plug from wall outlet.
Do not use appliance for other than intended use.
A short power-supply cord is provided to reduce the risk resulting from becoming entangled in or tripping over a longer cord.
Longer extension cords may be used if care is exercised in their use.
If a longer extension cord is used, the marked electrical rating of the extension cord should be at least as great as the electrical rating of the appliance, and the cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by children or tripped over unintentionally.
Never immerse the sterilizer or power cord in water.
When in use, the sterilizer contains hot water. Be careful to avoid spilling or splashing water on yourself when removing contents from the sterilizer.
This appliance is intended for household use only.
Children shall not play with the appliance.
If the supply cord is damaged it must be replaced by the manufacturer, its service agent, or similarly qualified person in order to avoid hazard.
NOT FOR SPACE HEATING PURPOSES.
The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
Appliances are not intended to be operated by means of an external timer or separate remote-control system.
WARNING: Do not misuse this sterilizer other than for its intended use to avoid potential injury.
Surfaces are liable to get hot during use.

SAVE THESE INSTRUCTIONS

Thank you for buying the Dr. Brown’s™ Bottle Sterilizer and Dryer. It has been designed to provide moms, dads and other caregivers a simple, easy and reliable way to sterilize Dr. Brown’s® baby bottles and parts before feeding your baby. This appliance works by transforming water into intense steam heat which kills most common household germs. It holds up to six Dr. Brown’s baby bottles in addition to all associated parts. It also holds most major competitive brands of baby bottles. The unit can also be used to sterilize other items and accessories such as pacifiers, teethers, toys, cups, utensils and breast pump parts. They must be able to withstand boiling water in order to be sterilized in this unit. Please check with the manufacturer of the other items.
As parents we know how important your baby’s well being is, and this appliance will help you make your baby’s bottles and other feeding equipment more sterile.
Please read through the ENTIRE INSTRUCTION BOOK including the IMPORTANT SAFEGUARDS before using your new Dr. Brown’s™ Sterilizer with Dryer for the first time. A copy of these instructions is also available online at www.drbrowns.co/intl
IMPORTANT : Pour water into device before turning on.

PARTS

Lid
Tray
Removable Handle
Lower Rack
Base
Control Panel
Filter Cover
HEPA Type Filter
Measuring Cup

CONTROL PANEL

TO USE

Before running this appliance, it is important that all bottles, bottle parts and/or other accessories are clean. They must be washed, rinsed and empty.
Position the appliance on a flat surface and out of reach of children where it cannot be knocked or moved during operation. Remove the lower rack, tray, and lid from the base.
Fill the measuring cup to 110 mL with bottled water and pour the water
ONTO THE STAINLESS STEEL HEATING PLATE in the base.
CAUTION: DO NOT EXCEED the recommended amount of water.
NOTE: For best performance, use non-mineral bottled water and descale monthly.
Place the lower rack on the base and arrange bottles with the opening facing down over the posts of the lower rack. Place the bottle accessories (e.g. nipple/teat, collar, cap, etc.) on the tray. Always replace lower rack on base before turning the sterilizer on.
NOTE: If using Dr. Brown’s bottles and parts, see Figure A through Figure H on page 6 for suggested layout options. Both narrow and wide-neck bottles are shown.
Stack the tray on top of the lower rack and place the lid on top of the tray. Ensure that the lid fits securely on the tray without any gaps.
Plug the power cord into an electrical outlet and press the Power Button. NOTE: When the sterilizer is turned on, the appliance will beep and the indicator above the power button will light up. Choose your desired function following the instructions on pages 4 & 5.
STERILIZE ONLY FUNCTION
Complete steps 1 – 6 outlined on page 3 & 4, then press the “Sterilize Only”
button once. The appliance will beep one time and the sterilization cycle will start. NOTE: Be sure to add 110 mL of water. If there is not enough water added, incomplete sterilization may occur. If the unit was not able to sterilize completely, it will beep 5 times and the indicator light will flash (the unit will automatically power off after 2 hours). If this happens, wait 10 minutes to allow unit to
cool, then add 110 mL of water and re-start the sterilize cycle.
When the sterilization cycle is complete, the appliance will beep five times and switch off automatically.
NOTE: Wait 10 minutes to allow parts to cool before removing anything from the unit. NOTE: This cycle lasts approximately 9 minutes but may vary by the amount of water you add, the number of items to be sterilized and other environmental factors. CAUTION: Do not touch or reach over the lid, tray, or lower rack when sterilization is in process, as these surfaces get hot.
DRY ONLY FUNCTION:
Press the power button, then press the “Dry Only” button once. The appliance will beep one time and the drying cycle will start.
When the drying cycle is complete, the appliance will beep five times and switch off automatically.
NOTE: This cycle lasts approximately 45 minutes.
AUTOMATIC STERILIZE/DRY FUNCTION:
Complete steps 1 – 6 outlined on page 3 & 4, then press the “Automatic Sterilize/Dry Cycle” button once. The appliance will beep one time and the sterilization cycle will start.
NOTE: Be sure to add 110 mL of water. If there is not enough water added, incomplete sterilization may occur. If the unit was not able to sterilize completely, it will beep 5 times and the indicator light will flash (the unit will automatically power off after 2 hours). If this happens, wait 10 minutes to allow unit to
cool, then add 110 mL of water and re-start the automatic sterilize/dry cycle.
When the sterilization cycle is complete, the drying cycle will begin automatically. The drying cycle lasts approximately 45 mins.
CAUTION: As the unit switches from the sterilization to the drying cycle, it is expected to see a large initial release of steam as the fan turns on. Keep a safe distance from the unit while this cycle is in process.
When the drying cycle is complete, the appliance will beep 5 times and switch off automatically.
NOTE: Any cycle can be stopped at any time by pressing the power button.
CAUTION: If it is necessary to drain water from the base, always
POUR AWAY FROM YOU, as shown by the symbol on base.

over view

FIGURE A. Placement of narrow bottles
FIGURE B. Placement of narrow reservoir tubes
FIGURE C. Placement of narrow parts (nipples/teats, collars, caps, and travel discs)
FIGURE D. Placement of wide-neck reservoir tubes
FIGURE E. Placement of wide-neck bottles
FIGURE F. Placement of wide-neck caps (2 caps on bottom, 4 caps on top)
FIGURE G. Placement of wide-neck parts (nipples/teats, collars, caps, and travel discs)
FIGURE H. Placement of pacifiers/soothers, teethers, and other small parts

TO CLEAN THE APPLIANCE

The Dr. Brown’s Natural Flow® Bottle Sterilizer and Dryer should be cleaned at least once a week when in regular use. Wait at least 60 minutes after a cycle to allow the device to cool. Before cleaning your device, ALWAYS disconnect the power plug from the outlet.

The removable tray, lid, lower rack, and measuring cup can be cleaned in hot soapy water and rinsed completely.
The base exterior and heating chamber can be cleaned with a damp sponge or damp cloth.

CAUTION: DO NOT IMMERSE THE STERILIZER BASE IN WATER. DAMAGE TO ELECTRICAL COMPONENTS WILL RESULT.
DESCALING:
Mineral deposits, like limescale, may form on the metal heating element in the base. As the mineral deposits build, it can slow or disrupt the sterilization cycle. Depending on the water type in your area, mineral deposits may vary in appearance but the harder the water, the quicker it builds up. Mineral deposits are not known to be harmful, but they may impair the function of appliances or damage components. Using demineralized or non-mineral bottled water can help prevent buildup, but regular descaling is needed for best performance. To remove the mineral deposits, follow the steps below.

Unplug the device.
Remove the tray.
De-scale utilizing a 110 mL mixture of vinegar/water:
1. Fill measuring cup to 80 mL with white vinegar.
2. Add 30 mL water, for a total of 110 mL.
3. Pour directly over the heating element.
4. Reassemble empty unit.
5. Turn the unit on and run a sterilization cycle.
6. Empty any remaining solution and rinse with clean water.

NOTE : DO NOT USE BLEACH, HARSH ABRASIVES OR SOLVENTS TO CLEAN THE HEATING CHAMBER OR HEATING ELEMENTS AS THEY MAY CAUSE PERMANENT DAMAGE AND WILL VOID THE WARRANTY.

REPLACING HEPA TYPE FILTER:
For optimal performance, it is recommended to replace the filter every 6 months of regular use. Replace the filter by following the steps below.

Remove the filter cover from the bottom of the base and take out the old filter.
Place a new filter into the base, ensuring the pull tab is still visible on top of the filter.
Insert the filter cover back into the base.
NOTE: Filter must always be used to ensure proper performance.

WARRANTY

This appliance is warranted against defective material or workmanship for a period of one year from the date of purchase. Any defective part will be repaired or replaced at no charge if it has not been tampered with and the appliance has been used according to these printed instructions. This warranty gives you specific legal rights as well as other rights that vary from state to state.
This warranty does not cover a defect that has been caused by negligence, accidents or improper use of the appliance. To keep your Dr. Brown’sTM Bottle Sterilizer and Dryer in good condition and retain your warranty, USE ONLY AS DIRECTED.

CUSTOMER SERVICE
If you experience unsatisfactory operation or have questions/comments, please contact your local Dr. Brown’s distributor. See drbrownsbaby.com to find your local contact.