VISUAL COMFORT IKF2731 AI Arnav Large Torch Sconce Instruction Manual
- June 11, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT IKF2731 AI Arnav Large Torch Sconce
Product Information
Arnav Large Torch Sconce
The Arnav Large Torch Sconce is a light fixture designed to be mounted on
the wall. It comes with a mounting plate (A), set screws (D), mounting screws
(B), and a ground wire (bare copper). The product does not include a bulb. The
fixture should be installed in accordance with applicable local installation
codes by a person familiar with its construction and operation, as well as the
hazards involved. Care should be taken to inspect the item and contents
carefully before installation.
Product Usage Instructions
- Carefully remove all parts from the box and place them on a clean, soft surface.
- Using the provided screwdriver (C), remove set screws (D) and detach the mounting plate (A) from the fixture.
- Install mounting plate (A) to the junction box and secure it with mounting screws (B).
- Wrap fixture ground wire (bare copper) around the green grounding screw in the junction box and tighten it securely.
- Connect fixture wires to supply wires according to the local installation codes.
- Attach the fixture to the mounting plate (A) using set screws (D).
- Install a bulb (not included).
- Clean the fixture only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Note: This product is listed as UL Listed for use in the United States.
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install it. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
- Phillips Screwdriver
- Slotted Screwdriver
ASSEMBLY INSTRUCTIONS
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (A) from fixture by removing set screws (D) using provided screwdriver (C).
-
Install mounting plate (A) to the junction box and secure with the mounting screws (B).
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (E).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (E).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (E).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture to mounting plate (A) and secure with set screws (D) using provided screwdriver (C).
-
Install light bulb onto the socket.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>