Maxxima MRL-615205 5 Inch and 6 Inch LED Retrofit-Kit Installation Guide
- June 11, 2024
- Maxxima
Table of Contents
Maxxima MRL-615205 5 Inch and 6 Inch LED Retrofit-Kit Installation Guide
WARNINGS
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unsure about the installation or the maintenance of the fixture, please consult an electrician.
- Do not make or alter any holes in the wiring enclosure or modify any electrical componentry.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
CAUTIONS
- The fixture must be wired in accordance with the National Electric Code (N.E.C) standards and any applicable local codes or ordinances.
- This fixture is not compatable with photo controls, occupancy sensors, or timing devices.
- This fixture is designed for use with 120Vac, 50/60Hz only.
- The retrofit kit is accepted as a component of a luminaire where the suitability of the combination shall be determined by CSA or authorities having jurisdiction.
Electrical Parameters
Model| Input
Voltage| Input
Frequency| Input
Current| Input
Wattage
---|---|---|---|---
MRL-615205| 120 VAC| 60 Hz| 120mA| 13W
Product Dimensions
INSTALLATION INSTRUCTIONS
- Ensure the power has been turned off by switching the circuit breaker to the off position or by removing the fuse from the fuse panel.
- Remove and disconnect the existing fixture from the housing.
- Select the desired color temperature by moving the selector switch shown in figure 1.
- Twist the E26 adapter into the housing as shown in figure 2.
- Set the distance of the torsion springs for the size housing being used they are set at 6” from the factory, if using a 5” housing the springs must be moved to the inner most position.
- Connect the orange connector to the E26 adapter as shown in figure 3.
- Press the torsion springs together on both sides and ensure both torsion spring are in the slots within the housing as shown in figure 4.
- Push the fixture up until flush with ceiling as shown in figure 5.
- Restore power and the light is now operational.
3 YEAR WARRANTY
Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
[email protected]
866-MAXXIMA (629-9462)
www.maxximastyle.com
125 Cabot Court Hauppauge, NY 11788