MONSTER SM1 Bluetooth Sunglasses User Manual

June 9, 2024
Monster

MONSTER SM1 Bluetooth Sunglasses

MONSTER SM1 Bluetooth Sunglasses

OVERVIEW

Overview

PRODUCT SPECIFICATION

Model CW3-22003
Bluetooth Version V5.1
Bluetooth Protocol A2DP/AVCTP/AVDTP/AVRCP/HFP/SPP
Frequency level 2.402GHz – 2.480GHz
Distance 10M
Music playing time 6-7h
Phone call time 7h
Charging volt 5V
Charging time 2h
Standby time 200h
Battery 450833 3.7V 100mAh*2
Weight 38.5g
Shell material PC+TR90
Lens material PC
Charging port Magnetic suction

OPERATIONAL INSTRUCTIONS

Power On
  1. Touch to start (wear detection)
  2. Automatically enter Bluetooth pairing mode after power-on
Power Off
  1. No touch, let the glasses stand for 15 seconds to shut down.
  2. Power off automatically after charging
Function key on the left
  1. Touch and tap 2 times: answer the call/end the call
  2. Touch and click 2 times: next song
  3. Touch and click 1: Play/pause
  4. Touch and hold for 2s: voice assistant
  5. Touch and click 3 times: volume is reduced
Function key on the right
  1. Touch and tap 2 times: answer the call/end the call
  2. Touch and click 2 times: previous song
  3. Touch and click 1: Play/pause
  4. Touch and hold for 2s: reject the call
  5. Touch and click 3 times: volume increases
Function key on both sides
  1. Long press for 5S on both sides at the same time: force into the pairing, and give priority to the left and right mirror legs to form a team.
  2. Press and hold for 8S on both sides to clear the Bluetooth address or restore factory Settings.
Indicator light
  1. Switch on the blue indicator for 1S
  2. Pairing mode The red and blue lights blink alternately
  3. Charge the red light, full bright blue light
  4. Low power indicator: < 20%. The red light blinks
  5. Clear the Bluetooth address blinking red at short intervals

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference  received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on , the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals