MONSTER MH12005 Wireless Earbuds User Guide
- March 6, 2024
- Monster
Table of Contents
**MONSTER MH12005 Wireless Earbuds User Guide
**
Product Overview:
In-ear Earphone x 2 (left & right) Charging Case USB-C Charging Cable Ear Tips x 3 pairs (medium pre-installed) Quick Start Guide and Warranty Letter
- Multi Function Button (MFB)
- Ear Tip
- Earphone indicator
- Charging contact point
- Microphones
- Charging Case Indicator
- USB-C Charging Port
Power On/Off
Earphones will turn on when charging case is opened. To turn off, place the
earphones in the charging case, charging will start when cover is closed.
Charging Case Charging
Connect the USB-C cable (included) to the charging port. When charging the
charging case, the indicator light on the charging case flashes, and it will
stay on after being fully charged.
Pairing
Open the cover of the charging case and the earphones will turn on
automatically. Later, you can hear “pairing” as a voice prompt. To connect to
a new device, please turn on the Bluetooth of your mobile phone and search for
“Monster Achieve 300 AirLinks” to pairing the device. After successfully
connecting, you will hear “connected” voice prompt.
Volume Control
Volume down: Double tap the MFB on the left earphone during music streaming.
Volume up: Double tap the MFB on the right earphone during music streaming.
Call
Answer / End a call: Single tap the MFB. Reject the call: Press and hold the
MFB for 2 seconds.
Music
Play/Pause music: Single tap the MFB
Previous song: Press and hold the MFB on the left earphone for about 2
seconds.
Next song: Press and hold the MFB on the right earphone for about 2 seconds.
Indicator / Voice Prompt Guide
| Mode | Description | Voice Prompt |
|---|---|---|
| Power On | The blue indicator is on for 1 second | “Power On” |
| Power Off | The red indicator is on for 1 second | “Power Off” |
| Pairing | The red and blue lights of the primary earphones flash alternately, | |
| and the blue lights of the secondary earphones flash slowly | “Pairing” | |
| Connected | The red and blue indicators are off | “Connected” |
| Earphones charging | Put the earphones in the charging compartment, close the | |
| cover, turn off the earphones and charge them | – | |
| Charging case | When charging the charging case, the indicator light on the | |
| charging case flashes, and it will stay on after being fully charged | – |
Cautions
- After removing the earphones from the charging case, without pressing any buttons, the left and right earpieces will connect automatically. When no connections found, it will enter automatic pairing mode.
- Please place the earphones in the correct location (L/R) for normal charging.
- Replacement of battery (on your own) is not recommended.
- Do not expose battery (battery pack) to excessive heat such as direct sunlight or fire.
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC ID:2AVD2-MH12005
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolledenvironment. This equipment should be installed and operated with
minimum distance Ocmbetween the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>