ART SOUND IGNITEIONE ARTWSIGNBK True Wireless Earbuds and LED Multicolor Charging Case Instruction Manual
- June 9, 2024
- ART SOUND
Table of Contents
IGNITEIONE ARTWSIGNBK True Wireless
Earbuds and LED Multicolor Charging Case
Instruction Manual
IGIIITET011E
TRUE WIRELESS EARBUDS & LED MULTICOLOR CHARGING CASE
Instruction Manual
ARTWSIGNBK
IGNITEIONE ARTWSIGNBK True Wireless Earbuds and LED Multicolor Charging
Case
Before You Begin…
READ CAREFULLY AND KEEP THIS MANUAL
Caution
To ensure safe and proper use, read all safety information before using the
device. Only use with manufacturer-approved batteries, chargers, accessories,
and supplies.
- THIS DEVICE IS NOT A TOY, do NOT allow children or pets to use or play with this device.
- Do not disassemble, modify, or repair the device.
- Do not expose the unit to extreme temperatures (heat or cold), open flames, humid, or wet conditions.
- Do not submerge in water.
- Low power may cause poor Bluetooth connection or sound distortion.
- Do not overcharge battery.
- If using with a USB adapter, make sure the adapter is not damaged.
- Do not allow the USB port or the connectors of the supplied USB cable to be exposed to dust, or water, or come into contact with any conductive materials such as liquids, metallic powders, etc.
- The earbuds & case contain built-in batteries and should not be disposed of with regular household waste. Please consult the local authorities on the correct way to dispose of this device.
In the Box
- ARTWSIGNBK- True Wireless Earbuds
- USB Charging Cable
- Instruction Manual
Location of Controls
Getting Started
Charging the Case Plug the small connector of the included USB charging cable
into the charging port at the bottom of the case. Plug the large connector
into a USB power source such as the USB port on a computer, or a 5V USB wall
adapter (not included).
The charging case’s LED at the bottom will blink RED while charging.The LED
will be solid RED when the case is fully charged.
Charging the Earbuds
Make sure the case is charged.
To charge the earbuds, place them in the correct ports in the case. They will
automat is Ily begin charging. The earbud LED indicators will be solid RED
while charging then turn OFF when fully charged.
On low power, a tone will be heard from the earbuds, indicating charging is
required.
Powering ON/OFF
- The earbuds will automatically power ON when removed from the case. The earbud LED indicators will flash RED and White, then turn OFF when the earbuds are placed into the case.
- The earbuds can also be powered ON/OFF by pressing + holding (appx. 5s) the Multi buttons.
- When powered ON, the earbuds will automatically pair with one another. Once paired with a device, the earbuds will automatically re-pair with that device, so long as the device is within connection range (33 ft.) and Bluetooth is enabled.
- The earbuds will automatically power OFF if they have not paired to a Bluetooth device after 5 minutes.
Bluetooth Pairing
- Power the earbuds ON. Both of their LED indicators will flash RED and WHITE
- After a moment, a voice will be heard on the earbuds indicating that they have paired to each other. The LED indicator on the main earbud will flash RED and WHITE , and the LED indicator on the secondary earbud will turn OFF.
- Set your mobile device to search for Bluetooth devices. When it appears, select ARTWSIGN from the list of found devices.
- Once successfully paired, a tone will be heard, and the LED indicator will turn OFF.
Playback will be controlled from your paired device, or the controls listed below.
- lx Press either Multi button to pause playback. Press again to resume.
- 3x press the RIGHT Multi button to decrease the volume.
- 3x press the LEFT Multi button to increase the volume.
- 2x press the RIGHT Multi button to skip to the previous track.
- 2x press the LEFT Multi button to skip to the next track.
Phone Calls
When paired to a phone via Bluetooth, you can control phone functions using
the controls listed below.
- lx Press either Multi button to answer an incoming phone call.
- lx Press either Multi button to hang up a call.
- Press + hold (appx. 1.5s) either Multi button to reject an incoming phone call.
Activating Voice Assistant
- Press + hold (appx. 2s) either Multi button to activate your device’s voice assistant.
Compliance Information
FCC Information
This device complies with Part 15 of the FCC Rules.
CAUTION: Any changes or modifications not expressly approved could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radiation Exposure Information
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
WARNING Li-ion Battery Inside
This product is fitted with a Li-ion battery. Do not damage, open, or
dismantle the battery and do not use it in damp and/or corrosive conditions.
Use only with compatible chargers. Never dispose of batteries in a fire, and
never expose them to high temperatures. Do not expose the product to
temperatures exceeding 60°C (140°F).
Rating Label Definitions
Direct current symbol.
This symbol signifies the product must not be discarded as household waste,
and should be delivered to an appropriate collection facility for recycling.
Proper disposal and recycling helps protect natural resources, human health
and the environment.
This symbol signifies and declares that this equipment has battery charging
which complies with California CEC and energy efficiency.
**** This symbol signifies that this is a wireless device powered by
Bluetooth technology. The Bluetooth. word mark and logos are registered
trademarks owned by Bluetooth SIG. Inc. used under license.
Warranty Information
90-Day Limited Warranty
Territory: United States
LIMITED WARRANTYTO ORIGINAL CONSUMER
This product as supplied and distributed new by an authorized retailer is
warranted by Southern Telecom, Inc. to the original consumer purchaser against
defects in materials and workmanship (“Warranty”) as follows:
To obtain warranty service:
- Visit our customer support portal: www.customersupport123.com and select “Support”
- Select the brand, fill out the corresponding form (exchanges require dated proof of purchase from an authorized retailer) then submit your request.
Your product will be repaired or replaced, at our option, for the same or
similar model of equal value if examination by the service center determines
this product is defective. Products received damaged as a result of shipping
will require you to file a claim with the carrier.
Warranty service not provided
This warranty does not cover damage resulting from accident, misuse, abuse,
improper installation or operation, lack of reasonable care, unauthorized
modification including software modifications such as the installation of
custom firmware. This warranty is voided in the event any unauthorized person
opens, alters or repairs this product. All products being returned to the
authorized service center for repair must be suitably packaged.
NO WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY
IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE,
OTHER THAN THOSE EXPRESSLY DESCRIBED ABOVE SHALL APPLY. DISTRIBUTOR FURTHER
DISCLAIMS ALL WARRANTIES AFTER THE EXPRESS WARRANTY PERIOD STATED ABOVE. NO
OTHER EXPRESS WARRANTY OR GUARANTY GIVEN BY ANY PERSON, FIRM OR ENTITY WITH
RESPECT TO THE PRODUCT SHALL BE BINDING ON DISTRIBUTOR. REPAIR, REPLACEMENT OR
REFUND OF THE ORIGINAL PURCHASE PRICE – AT DISTRIBUTOR’S SOLE DISCRETION – ARE
THE EXCLUSIVE REMEDIES OF THE CONSUMER. IN NO EVENT WILL DISTRIBUTOR OR ITS
MANUFACTURERS BE LIABLE FOR ANY INCIDENTAL, DIRECT, TO, DAMAGES FOR LOSS OF
PROFITS, BUSINESS, SAVINGS, DATA OR RECORDS) CAUSED BY THE USE, MISUSE OR
INABILITY TO USE THE PRODUCT EXCEPT AS STATED HEREIN, NO OTHER WARRANTIES
SHALL APPLY. NOTWITHSTANDING THE FOREGOING, CONSUMER’S RECOVERY AGAINST
DISTRIBUTOR SHALL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT SOLD BY
DISTRIBUTOR. THIS WARRANTY SHALL NOT EXTEND TO ANYONE OTHER THAN THE ORIGINAL
CONSUMER WHO PURCHASED THE PRODUCT AND IS NOT TRANSFERABLE.
Some countries, states or provinces do not allow the exclusion or limitation
of incidental or consequential damages or allow limitations on warranties, so
limitation or exclusions may not apply to you. This warranty gives you
specific legal rights, and you may have other rights that vary from state to
state or province to province. Contact your authorized retailer to determine
if another warranty applies.
All product names, trademarks, and registered trademarks are property of their
respective owners. All company, product, and service names used in this
document are for identification purposes only. Use of these names, trademarks,
and brands does not imply endorsement.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
Designed in US
Printed in China
v1. 01-2023 