BIG ASS FANS FR127C-U1H HAIKU L 52 Inch Indoor White Ceiling Fan

Product Information

The Haiku L is an exceptionally engineered fan available in five different models: FR127C-U1H, FR150C-U1H, FR127C-U1J, FR150C-U1J, and FR112C-U1H. The maximum power consumption for each model is as follows: FR127C-U1H: 39 W, FR150C-U1H: 55 W, FR127C-U1J: 33 W, FR150C-U1J: 34 W, and FR112C-U1H: 36 W. The fan comes with a mounting bracket, control box, steel pin, bolts, screws, airfoils, wiring cover, extension tube, motor cover trim, motor cover, motor unit, and a wiring and safety cable (not shown).

Product Usage Instructions

1. Before starting the installation process, turn off the power at the breaker and ensure that the power source is not damaged. Do not attempt to resolve electrical failures on your own. Contact a licensed electrician if you are uncomfortable performing electrical work. A licensed electrician must install the fan if required by local code.
2. Gather the necessary tools and hardware listed in the user manual.
3. Install the mounting bracket to the ceiling or joist using suitable hardware. For concrete mounting, use the anchor bolts and anchor hook included with your fan. For wood ceiling joist mounting, use two corrosion-resistant 12-11 x 45 mm hex head timber screws with seal. If required by local code, mount or embed an outlet box into the joist. The outlet box must be suitable for fan support.
4. Route power wiring to the fan location and connect wires from the mounting bracket to the supply power wires. Ensure wire connectors are turned upward and that wires are spread apart with grounded conductors on one side of the outlet box/mounting structure and ungrounded conductors on the other side.
5. Carefully tuck wiring into outlet box or building structure so that only the wiring harness is hanging out.
6. Attach the airfoils to the motor unit using the M5 airfoil screws.
7. Attach the motor cover trim to the motor cover using the M3 motor cover screws.
8. Attach the motor cover to the motor unit.
9. Install the fan assembly onto the mounting bracket using the mounting ball and wedge.
10. Install the control box onto the motor unit using the M8 bolt, washer, and nut.
11. Attach the wiring cover to the control box.
12. Secure the fan assembly to the mounting bracket using the 6 mm steel pin.
13. If required by local code, install an M6 anchor hook for the safety cable.

BEFORE YOU START

Turn off Power at Breaker

• Input Voltage: 100–240 VAC, 1 Φ, 50/60 Hz
• Watts Puissance: FR127C -U1H: 39 W max. | FR150C-U1H: 55 W max. | FR127C-U1J: 33 W max. | FR150C-U1J: 34 W max. FR112C-U1H: 36 W max.

Do not connect the fan to a damaged power source. Do not attempt to resolve electrical failures on your own. Contact a licensed electrician if you are uncomfortable performing electrical work. A licensed electrician must install the fan if required by local code.

• WARNING: Installation must be in accordance with the requirements set forth by the National Electrical Code (NEC, United States), ANSI/NFPA 70, and all national and local codes.
• The ground wire must be connected to the supply ground and its length must be longer than the safety cable.
• A means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
• The mounting/fixing means for attachment to the ceiling such as hooks or other devices shall be fixed with a sufficient strength to withstand four times the weight of the ceiling fan.

Gather Tools

PARTS AND HARDWARE

Wiring and safety cable not shown.

Install Mounting Bracket

Outlet Box
WARNING: Mount only to an outlet box marked acceptable for fan support.
Secure mounting bracket to outlet box with suitable hardware (not supplied).

Concrete Ceiling
Route power wiring to fan location. Use mounting bracket as drilling template and drill four holes. Attach mounting bracket to ceiling using four M6 anchor bolts. If required by local code, install an M6 anchor hook for safety cable.

Wood Ceiling Joist
Route power wiring to fan location. Attach mounting bracket to joist using two wood screws (not supplied). Recommended: Corrosion-resistant 12-11 x 45 mm hex head timber screws with seal. If required by local code, mount or embed an outlet box into the joist. The outlet box must be suitable for fan support.

Wire Fan

Disconnect power before wiring fan.
Connect wires from mounting bracket to supply power wires. Carefully tuck wiring into outlet box or building structure so that only the wiring harness is hanging out. Ensure wire connectors are turned upward and that wires are spread apart with grounded conductors on one side of the outlet box/mounting structure and ungrounded conductors on the other side.

Supply Power Wire Color Chart

North America 100–120 V

AC Hot/L1 Black

| Australia

Brown or Red

| All other regions

Brown

---|---|---
AC Neutral/L2 White| Black or Light Blue| Blue
PE/Earth Ground Green or Bare Copper| Green with Yellow|

Install Airfoils and Motor Cover

Align each airfoil on fan hub and secure with airfoil screws. Make sure sticker on airfoil matches corresponding sticker on fan hub. Tighten screws to 2.5 N·m (22.1 in·lb) in sequence shown below. Secure motor cover to motor unit with motor cover screws.

Over-tightening screws may cause airfoils to warp and void your warranty.

Install Extension Tube and Motor Cover Trim

Install Wiring Cover and Mounting Ball

1. Slide wiring cover down extension tube. Slide mounting ball over extension tube.
2. Insert steel pin into hole at top of extension tube. Slide mounting ball upward, seating steel pin in inner slots of ball.
3. Insert wedge into mounting ball and secure with screw. Tighten screw enough to prevent movement between mounting ball and extension tube.

Install Control Box and Hang Fan

1. Insert control box into mounting bracket.
2. Raise fan to mounting bracket. Align rib in mounting bracket with slot in mounting ball, position mounting ball, and let fan hang freely. Gently twist extension tube to ensure it is properly seated and will not move during fan operation.

Connect Wiring Harnesses and Earth/Ground Wire

1. Connect wiring harnesses from extension tube (2) to wiring harnesses on back of control box (2). Secure green Earth/Ground wire from extension tube to mounting bracket with ground screw.
2. Connect wiring harness from ceiling to wiring harness on front of control box. Peel backing off double-sided tape on mounting bracket and affi x ferrite core to tape.

Secure Safety Cable

Some local safety codes require ceiling fans to be secured directly to the building structure (Canada, Singapore). Check your local safety code if you are unsure. Contact Customer Service for help.

Anchor Hook
Wrap upper end of safety cable around anchor hook. Secure with shackle.

Building Structure
Wrap upper end of safety cable around building structure. Secure with shackle. Acceptable building structures include a wooden beam or a metal mounting brace secured between two beams. In some cases it may be necessary to install additional structural material to provide attachment points.

Secure Wiring Cover

Slide wiring cover up extension tube, aligning yellow arrow stickers so that top of wiring cover sits fl ush with mounting bracket. Make sure all wiring is tucked into wiring cover, and then twist wiring cover clockwise to lock.

Use only with light kits marked “Suitable for Use in Wet Locations.”
Use only light kit models TM3191-001 and TM3191-003. Light Kit Weight: 0.64 lb (290 g)

REMOTE CONTROL

Do not expose the remote control to rain or water.

• Turns fan on or off.
• Turns light on or off.
• Increases fan speed/light brightness.
• Decreases fan speed/light brightness.
• Sets fan timer length of up to eight hours. Each press extends timer by one hour.
• Clears active fan timer.
• Varies fan speed to simulate a natural breeze.
• Automatically adjusts your fan speed overnight to keep you comfortable while you sleep.

For operation, maintenance, and troubleshooting information, visit bigassfans.com/support.

BIG ASS FANS MOBILE APP*

Download the Big Ass Fans mobile app to group multiple fans, adjust their settings, and set your comfort preferences for hands-free control. For smart device integration instructions, visit www.bigassfans.com/support.

*Mobile app requires Wi-Fi module to be installed in fan.

ANNUAL MAINTENANCE

Perform these procedures each year to keep your fan running smoothly.

• Safety Cable. Check safety cable is properly installed and secure.
• Hardware. Make sure all hardware is securely fastened.
• Wiring. Check power wiring and ground connections.
• Cleaning. Dust the airfoils and wipe clean with a damp cloth and ordinary soap and water.

CONTACT US

United States
2348 Innovation Drive
Lexington, KY 40511
USA
877-244-3267
Outside the U.S. (+1 859-233-1271)
bigassfans.com
Australia
35 French Street
Eagle Farm, Brisbane
QLD 4009
Australia
+61 1300 244 277
bigassfans.com/au
Singapore
50 Ubi Crescent

01-01 Ubi TechPark

Singapore 408568
+65 6709 8500
bigassfans.com/sg
All Other Geographies
+1 859-410-6286
bigassfans.com
Canada
2180 Winston Park Drive
Oakville, Ontario L6H 5W1
Canada
1 844-924-4277
bigassfans.com/ca
Mexico
CEBSA (Corporación Eléctrica del Bravo SA de CV)
Avenida Ind. Rio San Juan
Lote 3-A Parque Industrial del Norte
Reynosa, Tamps C.P. 88736
+52 1 899 925 6398
http://cebsainc.com/
Fluid Equipment Supply Company S de RL de CV
Blvd. Adolfo Lopez Mateos 2292-4
Col. Zona Industrial, CP 21389, Mexicali, BC, Mexico
+52 686-561-4616
Gomez & Hilman Home Appliances SA de CV
Valerio Gonzalez Canseco 714 L-1
Colonia Primero de Mayo, San Jose del Cabo B.C.S.
Mexico CP 23406
Cell Phone: 6241416065
Office Phone: 6241421359

Haiku is a trademark of Delta T LLC, registered in the U.S. and/or other countries. The information contained in this document is subject to change without notice.
For the most up-to-date information, see the online printable installation guide at www.bigassfans.com/support/haiku-l Google Play is a trademark of Google LLC.

www.bigassfans.com/patents
www.bigassfans.com/product-warranties

References

• Big Ass Fans
• Big Ass Fans Australia - Comfort Solutions For Your Home or Business
• Canada HVLS & Overhead Ceiling Fans - Big Ass Fans
• Big Ass Fans - Comfort Solutions For Your Home or Business
• Support - Big Ass Fans®
• Home | CEBSA
• Patents - Big Ass Fans®
• Product Warranties - Big Ass Fans®
• Support - Big Ass Fans®
• Haiku L Support - Big Ass Fans®

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>