BIG ASS FANS FR127C-U1H Haiku L Ceiling Fan

BEFORE YOU START

Turn off Power at Breaker

• Input Voltage: 100–240 VAC, 1 Φ, 50/60 Hz
• Watts Puissance | Vat iOS:
  FR127C-U1H: 39 W max.

Do not connect the fan to a damaged power source. Do not attempt to resolve electrical failures on your own. Contact a licensed electrician if you are uncomfortable performing electrical work. A licensed electrician must install the fan if required by local code.

WARNING: Installation must be in accordance with the requirements set forth by the National Electrical Code (NEC, United States), ANSI/NFPA 70, and all national and local codes.

Gather Tools

Models and Maximum Weight
FR127C-U1H (13.89 lb [6.3 kg]),

PARTS AND HARDWARE

Wiring and safety cable not shown.

Install Mounting Bracket

Outlet Box

WARNING: Mount only to an outlet box marked acceptable for fan support.

Secure mounting bracket to outlet box with suitable hardware (not supplied).

Concrete Ceiling
Route power wiring to fan location. Use mounting bracket as drilling template and drill four holes. Attach mounting bracket to ceiling using four M6 anchor bolts. If required by local code, install an M6 anchor hook for safety cable.

• If anchor bolts and anchor hook are included with your fan, use them for concrete mounting.

Wood Ceiling Joist
Route power wiring to fan location. Attach mounting bracket to joist using two wood screws (not supplied). Recommended: Corrosion-resistant 12-11 x 45 mm hex head timber screws with seal. If required by local code, mount or embed an outlet box into the joist. The outlet box must be suitable for fan support.

Wire Fan

Disconnect power before wiring fan.
Connect wires from mounting bracket to supply power wires. Carefully tuck wiring into outlet box or building structure so that only the wiring harness is hanging out. Ensure wire connectors are turned upward and that wires are spread apart with grounded conductors on one side of the outlet
box/mounting structure and ungrounded conductors on the other side.

Supply Power Wire Color Chart

| North America 100–120 V| Australia| All other regions
---|---|---|---
AC Hot/L1| Black| Brown or Red| Brown
AC Neutral/L2| White| Black or Light Blue| Blue
PE/Earth Ground| Green or Bare Copper| Green with Yellow| Green with Yellow

Install Airfoils and Motor Cover

Align each airfoil on fan hub and secure with airfoil screws. Make sure sticker on airfoil matches corresponding sticker on fan hub.
Tighten screws to 2.5 N·m (22.1 in·lb). Secure motor cover to motor unit with motor cover screws.

Over-tightening screws may cause airfoils to warp and void your warranty.

Install Extension Tube and Motor Cover Trim

1. Secure Extension Tube & Tighten Hardware

2. Connect Earth/Ground Wire

3. Connect Safety Cable
   

4. Plug In Wiring Harnesses

5. Reduce Slack

6. Slide Down Trim
   

Install Wiring Cover and Mounting Ball

• Slide wiring cover down extension tube. Slide mounting ball over extension tube.

• Insert steel pin into hole at top of extension tube. Slide mounting ball upward, seating steel pin in inner slots of ball.

• Insert wedge into mounting ball and secure with screw. Tighten screw enough to prevent movement between mounting ball and extension tube.

Install Control Box and Hang Fan

Insert control box into mounting bracket

Raise fan to mounting bracket. Align rib in mounting bracket with slot in mounting ball, position mounting ball, and let fan hang freely.
Gently twist extension tube to ensure it is properly seated and will not move during fan operation.

Connect Wiring Harnesses and Earth/Ground Wire

Connect wiring harnesses from extension tube (2) to wiring harnesses on back of control box (2). Secure green Earth/Ground wire from extension tube to mounting bracket with ground screw.

Connect wiring harness from ceiling to wiring harness on front of control box. Peel backing off double-sided tape on mounting bracket and affi x ferrite core to tape.

Secure Safety Cable

Some local safety codes require ceiling fans to be secured directly to the building structure (Canada, Singapore). Check your local safety code if you are unsure. Contact Customer Service for help.

Anchor Hook
Wrap upper end of safety cable around anchor hook. Secure with shackle.

Building Structure
Wrap upper end of safety cable around building structure. Secure with shackle. Acceptable building structures include a wooden beam or a metal mounting brace secured between two beams. In some cases it may be necessary to install additional structural material to provide attachment points.

Secure Wiring Cover

Slide wiring cover up extension tube, aligning yellow arrow stickers so that top of wiring cover sits flush with mounting bracket. Make sure all wiring is tucked into wiring cover, and then twist wiring cover clockwise to lock.

Use only with light kits marked “Suitable for Use in Wet Locations.”
Use only light kit models TM3191-001 and TM3191-003. Light Kit Weight: 0.64 lb (290 g)

REMOTE CONTROL

Do not expose the remote control to rain or water.

• Turns fan on or off.
• Turns light on or off.
• Increases fan speed/light brightness.
• Decreases fan speed/light brightness.
• Sets fan timer length of up to eight hours. Each press extends timer by one hour.
• Clears active fan timer.
• Varies fan speed to simulate a natural breeze.
• Automatically adjusts your fan speed overnight to keep you comfortable while you sleep.

For operation, maintenance, and troubleshooting information, visit bigassfans.com/support

ANNUAL MAINTENANCE

Perform these procedures each year to keep your fan running smoothly.

• Safety Cable. Check safety cable is properly installed and secure.
• Hardware. Make sure all hardware is securely fastened.
• Wiring. Check power wiring and ground connections.
• Cleaning. Dust the airfoils and wipe clean with a damp cloth and ordinary soap and water.

CONTACT US

United States

• 2348 Innovation Drive
• Lexington, KY 40511
• USA
• 877-244-3267
• Outside the U.S. (+1 859-233-1271)
• bigassfans.com

Australia

• 35 French Street
• Eagle Farm, Brisbane
• QLD 4009
• Australia
• +61 1300 244 277
• bigassfans.com/au

Singapore

• 50 Ubi Crescent

• 01-01 Ubi TechPark

• Singapore 408568
• +65 6709 8500
• bigassfans.com/sg

All Other Geographies

• +1 859-410-6286
• bigassfans.com

Canada

• 2180 Winston Park Drive
• Oakville, Ontario L6H 5W1
• Canada
• 1 844-924-4277
• bigassfans.com/ca

Mexico

• CEBSA (Corporación Eléctrica del Bravo SA de CV)
• Avenida Ind. Rio San Juan
• Lote 3-A Parque Industrial del Norte
• Reynosa, Tamps C.P. 88736
• +52 1 899 925 6398
• http://cebsainc.com/
• Fluid Equipment Supply Company S de RL de CV Blvd. Adolfo Lopez Mateos 2292-4
• Col. Zona Industrial, CP 21389, Mexicali, BC, Mexico+52 686-561-4616
• Gomez & Hilman Home Appliances SA de CV Valerio Gonzalez Canseco 714 L-1
• Colonia Primero de Mayo, San Jose del Cabo B.C.S. Mexico CP 23406
• Cell Phone: 6241416065
• Office Phone: 6241421359

Haiku is a trademark of Delta T LLC, registered in the U.S. and/or other countries.
The information contained in this document is subject to change without notice.
For the most up-to-date information, see the online printable installation guide at www.bigassfans.com/support/haiku-l
www.bigassfans.com/patents
www.bigassfans.com/product-warranties

References

• Big Ass Fans
• Big Ass Fans Australia - Comfort Solutions For Your Home or Business
• Canada HVLS & Overhead Ceiling Fans - Big Ass Fans
• Big Ass Fans - Comfort Solutions For Your Home or Business
• Support - Big Ass Fans®
• Home | CEBSA
• Patents - Big Ass Fans®
• Product Warranties - Big Ass Fans®
• Haiku L Support - Big Ass Fans®

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>