Zhongyi Electronic A60 Intelligent Bulb Remote Control User Manual

June 6, 2024
Zhongyi Electronic

Zhongyi Electronic fgr1

Zhongyi Electronic A60 Intelligent Bulb Remote Control

Over view

Zhongyi Electronic fgr2

Night light mode: 3000K 201′ brightness
Reading mode: 4000K (■i.xed light mode) 501i brightness
Working mode: 6000K 501′ brightness
Breastfeeding mode: 3000K 50\ brightness
Color temperature switching code: cyclically switch between 3000K-4000K—6000K- 3000K
Pairing process: disconnect the POwer supply-long press the 0N button–connect
the power supply-flicker once, the pairing is successful
Code clearing process: The connected remote control is powering on and off the product 5 times, the main light source flashes, and the controller clearing code is successful.

Memory mode: the mode before the last power failure ,ras 3000K 60′, when
the light is turned on. press the Iii key to return to the last mode.

Brightness adjustment mode: 5′-100% Color temperature mode: 3000K—6000K
Light off mode: click the OW button
Remote control matching bulb parameters: Color temperature range: 3000K–6000K
Power: 9T
Voltage range: 100–240VAC
Lwainous flux: 800111
Color rendering index: above 80

FCC Information to User

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is con-nected.
  • Consult the dealer or an experienced radio/TV technician for help.

Caution
Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Compliance Information : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals