GDP 2006-2010 6.6L DuraMax Digital Switch User Manual

June 10, 2024
GDP

GDP 2006-2010 6.6L DuraMax Digital Switch User Manual
GDP 2006-2010 6.6L DuraMax Digital Switch

Disclaimer

  • By installing this product onto your vehicle, you assume all risk and liability associated with its use.
  • GDP Tuning, LLC. is not responsible for misuse of its products. By installing this product, you release GDP Tuning, LLC. of any and all liability associated with its use.
  • The purchaser and end user releases, indemnities, discharges and holds harmless GDP Tuning, LLC. from any and all claims, damages, causes of action, injuries, or expenses resulting from or relating to the use or installation of this product that is in violation of the terms and conditions on this page, the product disclaimer, and/or the product installation instructions. GDP Tuning, LLC. will not be liable for any direct, indirect, consequential, exemplary, punitive, statutory, or incidental damages or fines caused by the use or installation of this product.

Caution
Never work on a hot vehicle. Serious injury in the form of burns can result if the vehicle has been in use. Allow vehicle to cool prior to installation. Always wear eye protection when working on or under any vehicle.

OVERVIEW

A. GDP RGB Digital Switch
B. Ford Fuel Temp Sensor Plug
C. Flex Lume
D. USB Cable
E. Digital Switch Harness

Step 1
INSTRUCTION
Locate ECM plug

Step 2
INSTRUCTION

Remove the larger plug

Step 3
INSTRUCTION

Remove purple locking clip Do not lose

Step 4
INSTRUCTION

Remove top cover

Step 5
INSTRUCTION

Insert ORANGE wire into pin 46 Reverse procedures when finished

Step 6
INSTRUCTION

Pin-out reference (Viewed looking at connector face)

Troubleshooting

To troubleshoot your switch, you will need a voltmeter.

STEPS

Step 1
Set your switch to position 1.
Step 2
Turn key to the run position. (engine off or on)
Step 3
Test the Switch on the fly wire (Orange Wire). These numbers may vary within their specific levels. (i.e. 4.0-4.9 in Position 1) The voltage you should be seeing is:
Step 4
If the readings do not match, please check your connections and pins to make sure they are not bent or broken. As well as, there is no debris stopping the pins from being inserted completely.
Step 5
If the issue persists please call our tech support line for more help. 877-223-5018

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals