TOOLCRAFT 2612818 1000lm LED Torch Light Instruction Manual
- June 10, 2024
- Toolcraft
Table of Contents
Operating Instructions
LED Torch Light (1000 lm)
Item no: 2612818
Intended use
The product is an LED torch light.
The product has an IP54 ingress protection rating and has limited protection
from dust and water splashing from any direction. The product is suitable for
outdoor use. Do not submerge the product in water.
If you use the product for purposes other than those described, the product
may be damaged.
Improper use can result in short circuits, fires, electric shocks or other
hazards.
The product complies with the statutory national and European requirements.
For safety and approval purposes, you must not rebuild and/or modify the
product.
Read the operating instructions carefully and store them in a safe place. Make
this product available to third parties only together with the operating
instructions.
All company names and product names are trademarks of their respective owners.
All rights reserved.
USB4®, USB Type-C® and USB-C® are registered trademarks of USB Implementers
Forum.
Delivery contents
- LED torch
- USB-C® to USB-A charging cable
- Operating instructions
Latest product information
Download the latest product information at www.conrad.com/downloads or scan the QR code shown. Follow the instructions on the website.
Description of symbols
The following symbols are on the product/appliance or are used in the text:
**** The symbol warns of hazards that can lead to personal injury.
The symbol warns of dangerous voltage that can lead to personal injury by
electric shock.
Possibly hazardous optical radiation emitted from this product. Do not stare
at operating lamp. May be harmful to the eyes.
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on
proper handling, we assume no liability for any resulting personal injury or
damage to property. Such cases will invalidate the warranty/guarantee.
5.1 General
- The product is not a toy. Keep it out of the reach of children and pets.
- Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
- If you have questions which remain unanswered by this information product, contact our technical support service or other technical personnel.
- Maintenance, modifications and repairs must only be completed by a technician or an authorised repair centre.
5.2 Handling
- Handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
5.3 Operating environment
- Do not place the product under any mechanical stress.
- Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam and solvents.
- Protect the product from direct sunlight.
5.4 Operation
- Consult an expert when in doubt about the operation, safety or connection of the product.
- If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. DO NOT attempt to repair the product yourself. Safe operation can no longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient conditions or
– has been subjected to any serious transport-related stresses.
5.5 Li-ion battery
- Never damage the rechargeable battery. Damaging the casing of the rechargeable battery might cause an explosion or a fire!
- Never short-circuit the contacts of the rechargeable battery. Do not throw the battery or the product into fire. There is a danger of fire and explosion!
- Charge the rechargeable battery regularly, even if you do are not using the product. Due to the rechargeable battery technology being used, you do not need to discharge the rechargeable battery first.
- Never charge the rechargeable battery of the product unattended.
- When charging, place the product on a surface that is not heat-sensitive. It is normal that a certain amount of heat is generated during charging.
5.6 LED light
- Do not look directly into the LED light!
- Do not look into the beam directly or with optical instruments!
Risk Group 2
CAUTION
Possibly hazardous optical radiation emitted from this product.
The product belongs to LED risk group 2. The scope of delivery includes LED
notice signs in different languages. If the notice sign on the product is not
in your local language, attach the corresponding sign to your device.
5.7 Photosensitive epilepsy
People suffering from photosensitive epilepsy are susceptible to seizures or
loss of consciousness if exposed to flashing lights or light patterns.
Battery
Note:
Remove the plastic battery insulation strip when using for the first time.
6.1 Recharge the battery
- Open the USB cover to access the charging port.
- Connect one end of the charging cable to the charging input on the product.
- Connect the other end of the charging cable to a suitable power supply.
- Close the USB cover when charging is complete. Make sure it is properly sealed.
6.2 Replace the battery
- Unscrew then remove the battery cover.
- Insert a battery matching the polarity shown inside.
- Replace the battery compartment cover. Make sure the seal around the battery compartment cover is seated properly.
Status indicator light
| Status | Description |
|---|---|
| Green ON | Battery charged |
| Red ON | Battery charging |
Operation
8.1 Light (low/med/high)
Press the function button repeatedly to toggle through modes: low → medium →
high → OFF.
8.2 Strobe/SOS
Preconditions:
Light is switched OFF.
- Press and hold the function button to switch the strobe ON.
- Short press the function button to cycle through modes: SOS → OFF.
Cleaning and care
Important:
- Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions. They damage the housing and can cause the product to malfunction.
- Do not immerse the product in water.
1. Disconnect the product from the power supply.
2. Clean the product with a dry, fibre-free cloth.
Disposal
10.1 Product
This symbol must appear on any electrical and electronic equipment placed
on the EU market. This symbol indicates that this device should not be
disposed of as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and
accumulators, which are not enclosed by the WEEE, as well as lamps that can be
removed from the WEEE in a non-destructive manner, must be removed by end
users from the WEEE in a non-destructive manner before it is handed over to a
collection point.
Distributors of electrical and electronic equipment are legally obliged to
provide free takeback of waste. Conrad provides the following return options
free of charge (more details on our website):
- in our Conrad offices
- at the Conrad collection points
- at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the ElektroG End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of
WEEE may apply in countries outside of Germany.
10.2 (Rechargeable) batteries
Remove batteries/rechargeable batteries, if any, and dispose of them
separately from the product. According to the Battery Directive, end users are
legally obliged to return all spent batteries/rechargeable batteries; they
must not be disposed of in the normal household waste.
**** Batteries/rechargeable batteries containing hazardous substances are
labelled with this symbol to indicate that disposal in household waste is
forbidden. The abbreviations for heavy metals in batteries are: Cd = Cadmium,
Hg = Mercury, Pb = Lead (name on (rechargeable) batteries, e.g. below the
trash icon on the left).
Used (rechargeable) batteries can be returned to collection points in your
municipality, our stores or wherever (rechargeable) batteries are sold. You
thus fulfil your statutory obligations and contribute to environmental
protection.
Batteries/rechargeable batteries that are disposed of should be protected
against short circuit and their exposed terminals should be covered completely
with insulating tape before disposal. Even empty batteries/rechargeable
batteries can contain residual energy that may cause them to swell, burst,
catch fire or explode in the event of a short circuit.
Technical data
Charging input ………………………….. 5 V/DC 1 A (via USB-C®)
Rechargeable battery ………………… 2600 mAh 3.6 V Li-ion 18650
Intensity (max.) …………………………. 10,000 cd
Runtime (approx.)……………………… Low: 35 hrs, medium: 5 hrs, high: 2.5 hrs
Recharge time (approx.)…………….. 4 hrs
Ingress protection ……………………… IP54
Brightness (lm) …………………………. Low: 20, medium: 280, high: 1000 lm
Colour temperature……………………. 6500 K
Beam distance………………………….. approx. 200 m
Adjustable beam focus ………………. yes
USB cable length (approx.) ………… 50 cm
Operating conditions………………….. +5 to +28 °C
Storage conditions…………………….. 0 to +40 °C
Dimensions (L x ø) ……………………. 163.5 x (26 – 34) mm
Weight …………………………………….. 194 g (incl. battery)
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g.
photocopying, microfilming or the capture in electronic data processing
systems) requires prior written approval from the editor. Reprinting, also in
part, is prohibited.
This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.
*2612818_V1_0223_dh_mh_en 9007199954674827-2 I2/O1 en
http://www.conrad.com/downloads
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>