RAIN HARVESTING RHCL22 Leaf Eater Commercial Installation Guide
- June 10, 2024
- Rain Harvesting
Table of Contents
RAIN HARVESTING RHCL22 Leaf Eater Commercial
PRODUCT DETAILS
A steel rain head designed specifically for large-scale and commercial buildings. Suitable for high catchment and larger pipes. The angled mesh screen is easy to clean and filters leave and debris from your rain harvesting system.
Installation
- Leaf Eater Commercial Rain Head
TOOLS/MATERIALS YOU MAY REQUIRE
- Tape measure
- Marker pen
- Saw
- Bracket
- Screws
- Screwdriver or drill
GUTTER, EAVE & “MID” MOUNT
- Locate the position at which you will be installing your Leaf Eater Commercial rain head. Whether this is directly under your eave or midway down your downpipe, it should be a minimum of 500mm above your tank inlet and tank overflow pipe.
- Cut and bracket your bottom downpipe to the wall, being sure to offset it 30mm from the wall.
- Insert your Leaf Eater Commercial rain head into the pipe and mark the side flange fastening holes. Remove your rain head and prepare the necessary fastening points. Then reinsert your rain head and fasten it to the wall, ensuring it’s adequately supported by the wall structure.
- Cut your upper downpipe at an angle of 30 degrees to match the angle of your rain head’s stainless steel screen. Cut the pipe s0mm above the rain head screen and install it with a 30mm offset from the Wail.
Suggested Installation Orientations
Figure 1
Product Specifications
Leaf Eater Commercial
(Zincalume)
Fitting guide:
F Female / Socket Fitting
M Male/ Spigot Fitting (Pipe size)
IP = In-Pipe Fitting
Maintenance
Your rain head’s Clean Shield” screen is mostly self-cleaning. However, it is prudent to periodically inspect it to check if cleaning is necessary.
A common misconception about collecting rainwater is that all you need is a roof, a tank, and some rain. This ‘tanking’ approach cannot always be relied on to deliver the volume – or quality – of water that you require. That is where we can help.
With some thought, your rain harvesting system can provide you with cleaner water and lots of it. Whether you’re completely reliant on tank water or want to keep the garden green, our simple steps will help you achieve your goal.
The Rain Harvesting approach to rainwater collection involves using tested and proven products to make quality rainwater available for use in and around your property. You don’t need much to get started and you will be surprised how easy it is to get the most out of your rainwater system.
COMPLIANCE
-
enHealth Council
- Guidance on the Use of Rainwater Tanks
- Preventing Mosquitoes Breeding
-
AS/NZS 3500.3:2003 Plumbing and
Drainage Stormwater Drainage -
HB230:2008 Rainwater Tank Design
and Installation Handbook -
Queensland Health Regulations 1996
(Part 8 Mosquito Prevention
DISCLAIMER This product specification is not a complete guide to product usage. Further information is available from Rain Harvesting Pty Ltd and from the installation and Operating instructions. This specification sheet must be read in conjunction with the installation and Operating Instructions and all applicable statutory requirements. Product specifications may change without notice. O Rain Harvesting Pty Ltd
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>