Camfil h50 CleanSeal Exhaust Integrity Instructions
- June 10, 2024
- camfil
Table of Contents
Camfil h50 CleanSeal Exhaust Integrity Instructions
Housing Installation
| Filter Size| A| B
---|---|---|---
Square| 3P3| 374| 362
6P6| 679| 667
Rect.| 3P6| 374| 667
9P6| 679| 972
Std. Compression
Other ranges :
Contact Camfil for custom options
h<50 mm
h>50 … 105 mm
Optional Quick Clamping kit – locking plates available for wall thicknesses h:
h1 : 18-38 mm
h2 : 34-54 mm
h3 : 50-70 mm
Other ranges :
Contact Camfil for custom options
-
Insert housing into wall opening
-
Pre-position locking plates
-
Insert preset clamping bars and lock with screws
Door Locking & Unlocking
Simultaneously push door top corners to open / close
**Prefilter Exchange
**
- Open door & pull used filter out by the filter frame
- Insert new filter and slide it to the bottom
Door Removal / Insertion
-
Open door and remove pressure tube from door clips 1
-
Move the door to a position where door retainers are free from Stop-brackets
-
Gently slide door upwards to free hinges from slots
Adaptation piece installation
Main Filter Installation
-
Place filter on support rails
-
Adjust by turning the handle
PU: Turn to bottom GEL: Adjust to filter heig
To clamp the filter:
- Rotate the Clamp
- Close the handle
Clamp Settings
| Filter height | Clamp Config. PU |
|---|---|
| MD | A-1 |
| 78 | A-2 |
| MX | B-1 |
| MG | B-3 |
Clamp Position*
only for Megalam MG Illustration for PU
EMC_SPEC036_CR_E – CleanSeal Exhaust V3Quick Instructions 20.07.2020 Camfil AB – Sveavägen 56E – 11134 Stockholm – Sweden – +46 8 545 125 00 – www.camfil.com
References
- Air Filters & Air Filtration Solutions - USA | Camfil
- Air Filters & Air Filtration Solutions - USA | Camfil