VALORE AC162 Wireless Selfie/Tripod with Stabiliser User Manual
- June 3, 2024
- Valore
Table of Contents
VALORE AC162 Wireless Selfie/Tripod with Stabiliser
Wireless Selfie/Tripod with Stabiliser (AC162)
Thank you for purchasing the Valore Wireless Selfie/Tripod with Stabiliser (AC162). Please read the user manual thoroughly before using.
- Stabiliser power button
- Stabiliser charging port
- LED power/adjust button
- Telescopic pole
- Wireless shutter button
- Tripod
- Stabiliser unlock key
- LED
- LED charging port
- Manual tightening screw
Bluetooth connection
- Power on/off: Long press the shutter button
- Bluetooth pairing: The indicator flashes for 4 seconds before entering matching state. Search “AC162” on your mobile device and connect. The indicator will turn off when matching is successful. When not paired and left idle for 5 minutes, device will power off automatically. When paired and left idle for 10 minutes, device will power off automatically.
Stabilizer mode
Inception mode:
When mobile is landscape, counterclockwise 40°, clockwise 230°,
counterclockwise 230°, clockwise 20° When mobile is portrait, clockwise 125°,
counterclockwise 125° and 145°, clockwise 145°
260° Inception mode:
When mobile is landscape, clockwise 50° to counterclockwise 310°, start
recording with 1 second delay. When mobile is portrait, counterclockwise 310°
to clockwise 50°, start recording with 1 second delay.
Setting up wireless selfie/tripod
- Slide upwards to remove wireless shutter button
- Remove screw, slide the battery cover up to replace the battery
- Open tripod legs outward located at the bottom of the handle
How to secure mobile
- Clamp mobile and maintain balance. Long press the power button for 5 seconds to turn stabiliser on. Long press for 3 seconds to power off.
- Pull the ring of manual lock outwards, slide up to lock the stabiliser to use as a selfie stick. Slide up to unlock the stabiliser. (Note that the lock ring is pressed down and locked)
How to charge
- When the battery of stabiliser is low, there will be a red LED indicator flashing. Connect micro USB to the side of the stabiliser to charge. During the charging process, the red LED will light up. When fully charged, the red LED will be off.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>