Dextra Rubix Recessed Installation Guide

: June 9, 2024
: Dextra

Table of Contents

Rubix Recessed
Maintenance
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Rubix Recessed Installation
Installation Guide

Rubix Recessed

WARNING: Luminaire must be earthed. Risk of electric shock from LED boards if operated with cover removed. Installation / operation outside of luminaires intended scope invalidates warranty. Suitable only for domestic / light industrial / industrial applications within the scope of EN55015. Tested to compliance with BSEN 60598: specification for general requirements and tests. Must be installed by a suitably qualified person in accordance with all relevant legislation. Ambient operating temperature of 0°C to 25°C. If maximum operating temperature is exceeded luminaire will automatically dim / switch off.
Terminal blocks are rated to 16A unless stated otherwise. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
LUMINAIRES WITH EMERGENCY PACK: When supply is isolated battery output terminals may be live if battery is connected. Isolate mains and battery before servicing. Emergency luminaires require unswitched live connection taken from same phase as switched supply. When unswitched supply is connected status indicator illuminates green, when unswitched supply is disconnected indicator extinguishes and luminaire operates in emergency mode. 24 hour charge period required before undertaking full discharge test. Emergency test sheets provided should be used to record all emergency tests. Batteries should be replaced when 3 hour duration is not met. Excessive switching of permanent live may result in premature battery failure. Battery electrolyte can be harmful to eyes / open wounds, do not puncture, if electrolyte touches skin / eyes flush with water. Do not incinerate batteries.

1. Lift and tilt the lay-in frame into the ceiling grid as shown.| 2. Carefully lift and tilt the luminaire into the frame.
---|---
Dextra Rubix Recessed - | Dextra Rubix Recessed -
Carefully
3. Remove screwfrom terminal box and remove lid.| 4. Wire mains cable(s) into relevant marked terminals and replace cover and screw. Ensure cable clamps are engaged fully.
Dextra Rubix Recessed - Remove screw | Dextra
Rubix Recessed - relevant marked
5. For a pull-up version, insert tile into ceiling grid and use the Lumafix brackets to secure to the rear of ceiling grid.| 6. As previously demonstrated in steps 2 – 4, install luminaire and wire mains cable(s) as required.
Dextra Rubix Recessed - version |

Maintenance

Disconnect luminaire before undertaking any maintenanceor cleaning.
Cleaning should be undertaken on external partsof the luminaire only using a slightly damp lint free cloth.
To access LED tray use a pan pozi screwdriver to remove screws.
Use a pan pozi driver to remove components.
Please contact Dextra for assistance with spare components supply.